Poly(lactic acid) (PLA) and poly(butylene succinate) (PBS) were blended in a twin screw extruder at various contents of PBS from 0-50 wt%. PLA/PBS blends were melt spun using a single screw extruder equipped with multifilaments spinnerette. The effect of PBS contents on morphology, thermal and mechanical properties of PLA/PBS blend fiber was investigated SEM micrographs indicated that the addition of PBS at 10 wt% was miscible with PLA while the other contents of PBS exhibited phase separation in the blends. The incorporation of PBS affected on the declination of crystallinity in the blends. It can be noted that the addition of PBS could enhance the elasticity of PLA/PBS blend fibers
15 March 1993 in Proceedings of the National Academy of Sciences
The molecular chaperones GroEL and GroES were produced at very high levels in Escherichia coli, purified, and shown to protect pig mitochondrial malate dehydrogenase (MDH) against thermal inactivation in vitro. The apparent rate of MDH inactivation at 37 degrees C was reduced by a factor of at least 5 in a process which required only GroEL, GroES, and ATP. GroEL alone did not protect MDH against thermal inactivation but kept the denatured protein soluble and thereby prevented its aggregation. Reactivation of this soluble and inactive form of MDH could be achieved by addition of GroES even after 120 days of storage at -20 degrees C. Protection could be extended for more than 24 hr at 37 degrees C and was observed at molar ratios of chaperones to MDH as low as 1:4, suggesting that GroEL and GroES perform multiple turnovers in the absence of auxiliary chaperones. The availability of these chaperones in large quantities combined with the apparent promiscuity of GroEL binding shows great potential for stabilization of many proteins for which thermostable variants are not available. We speculate that GroEL and GroES perform similar protective roles in vivo and thereby increase the half-life of proteins which otherwise might aggregate under physiological conditions.
Biodegradable poly(lactic acid) (PLA) and poly(trimethylene terephthalate) (PTT) blend fibers were prepared in this study. PLA and PTT were blended in a twin screw extruder with varied contents of PTT 0-50 wt%.The PLA/PTT blend were melt spun into fiber by melt spinning technique. Thermal properties and crystallization behavior of PLA/PTT blends were investigated. PLA fiber was glossy and transparent while PTT fiber was opaque. The spinning of PLA/PTT blends fiber was difficult due to the difference in melting characteristic of PLA and PTT. However, the PLA/PTT blend fiber was successfully spun at PTT content of 10 wt% with the barrel temperature of 250C and would be suitable for textile application