Semi-Dense Asphalt (SDA) mixtures are nowadays recommended for the surface layer of low noise roads in urban areas due to their optimal functional characteristics. Moreover, the use of polymer-modified bitumen (PmB) in its design results in high mechanical performance. However, this type of highly modified bitumen implies significant economic and environmental disadvantages. The polymer modification increases the production cost, involves higher mixing temperatures, and makes the recycling process of the asphalt mixtures challenging. As a potential alternative to PmB in SDA mixtures, this experimental work analyses the dry process for the incorporation of crumb rubber (CR) from waste tires. Particularly, the main objective was to study the aging effect and the recyclability of asphalt mixtures prepared in the laboratory with two different types of CR. The volumetric properties and mechanical performance of the mixtures artificially aged and rejuvenated were evaluated. The results obtained show that mixtures with CR have adequate performance, being less susceptible to aging than a conventional polymer-modified mixture. Furthermore, the rheological response of asphalt binder samples recovered from the mixtures at different aging states was analyzed. It was observed that the effect of the rejuvenator depended on the CR type, but this fact did not negatively influence the performance of the recycled mixtures.
20 August 2019 in International Journal of Pavement Engineering
This research demonstrates the technical feasibility of replacing new raw materials by recycled and renewable alternative ones to make different sustainable asphalt mixes. In order to verify performance, a comparative analysis of different alternative materials was carried out. Electric arc furnace (EAF) slag, basic oxygen furnace (BOF) slag, waste foundry sand and reclaimed asphalt pavement (RAP) were used to replace natural aggregates in different proportions to enable the impact on asphalt concrete to be studied. Moreover, with the aim of restoring the properties of old binder from RAP and maximising the reduction in the amount of virgin binder needed, the effect of two rejuvenators was evaluated. The technical feasibility of using asphalt mixtures with a natural aggregate replacement rate of 80–98% was demonstrated at laboratory level. In this sense, the use of EAF and BOF slag to replace high-quality natural aggregate in the coarse fraction and the use of waste foundry sand to replace natural aggregate in the fine fraction proved to be a promising option. Furthermore, a significant virgin binder reduction was achieved with the combined use of RAP and rejuvenator, without compromising the mechanical performance of the mixtures.
The large number of kilometres of asphalt roads throughout the world represent a great consumption of resources in terms of not only the construction of new pavements but also the preservation and renovation of the existing ones. In this sense, the EU policy establishes as a priority target the optimal use of natural resources, the support to innovations that boost cost-effectiveness and the reduction and reuse of waste. The ALTERPAVE project (Use of end-of-life materials, waste and ALTERnative binders as useful raw materials for PAVEments construction and rehabilitation) is aimed at maximizing the amount of Reclaimed Asphalt Pavement (RAP) and several by-products such as slags and foundry sands in the design of asphalt mixtures. Furthermore, a spatial decision support tool will be developed to optimize the supply of these combinations of alternative materials according to not only their functional response, but also including economic, environmental and energy concerns.