This study reports the possibility of obtaining the WPI-based meringues with the small sucrose content (0–15%). The whey protein isolate (WPI) solution (20%, w/v) was whipped and sucrose was added to foam at the concentrations of 5, 10 and 15%. The surface tension, viscosity, zeta potential of the pre-foam solutions, foam overrun, foam stability and their rheological properties (G′, G″ and tan (δ)) were evaluated. To produce meringues, liquid foams were solidified at 130 °C for 2 h. The surface properties (roughness, contact angles, apparent free surface energy) as well as microstructural ones were determined for the solid foams (meringues). The 15% sugar concentration was detrimental for overrun, stability and rheological properties of liquid foams. The meringue production without sugar was infeasible. The addition of the smallest amount of sucrose (5%) enabled preservation of the aerated structure of the liquid foam during solidification. The 10% sugar concentration increased the stability of liquid foam, its rheology and it was the most effective for air bubbles stabilization during the foam solidification, however, its largest addition (15%) resulted in an increase in the final meringue volume. Larger sucrose concentrations produced a smoothing effect on the meringue surfaces.

The main objective of this study was to investigate the possibility of using a combination of vegetable proteins from soybean (SOY), rice (RPC), and pea (PEA) with liquid syrups: tapioca fiber (TF), oligofructose (OF), and maltitol (ML) in the application of high-protein bars to determine the ability of these ingredients to modify the textural, physicochemical, nutritional, surface properties, microstructure, sensory parameters, and technological suitability. Ten variants of the samples were made, including the control sample made of whey protein concentrate (WPC) in combination with glucose syrup (GS). All combinations used had a positive effect on the hardness reduction of the bars after the storage period. Microstructure and the contact angle showed a large influence on the proteins and syrups used on the features of the manufactured products, primarily on the increased hydrophobicity of the surface of samples made of RPC + ML, SOY + OF, and RPC + TF. The combination of proteins and syrups used significantly reduced the sugar content of the product. Water activity (<0.7), dynamic viscosity (<27 mPas∙g/cm³), and sensory analysis (the highest final ratings) showed that bars made of RPC + OF, SOY + OF, and SOY + ML are characterized by a high potential for use in this type of products.