The current trend is represented by replacing solid fats with structured liquid oil while maintaining the plastic properties of food products. In this study, the behavior of refined sunflower oil structured with various agents (carnauba wax-CRW, β-sitosterol:beeswax-BS:BW, β-sitosterol:lecithin-BS:LEC, and glycerol monostearate-GM) was evaluated in the process dynamics of oleogel-based tender dough products. The oleogel with the mixture of β-sitosterol:beeswax (OG_BS:BW) displayed the highest capacity to retain oil inside the matrix with a percentage of oil loss as low as 0.05% and also had a significantly higher hardness (6.37 N) than the reference, a commercial margarine (MR—3.58 N). During cooling from 90 to 4 °C, the increase in oleogel’ viscosity results from oleogelator’s liquid–solid phase transition. As demonstrated by the frequency sweeps performed, storage modulus G′ was higher than loss modulus G″, no cross-over points were observed, and the strongest gel network was for the oleogel with glycerol monostearate (OG_GM). Regarding the dough, the sample prepared using the oleogel with carnauba wax (D_CRW) showed the strongest hardness (92.49 N) compared to the reference (D_MR—21.80 N). All the oleogel-containing doughs had elastic solid-like behavior. The samples with margarine (D_MR) and the mixture of β-sitosterol:lecithin (D_BS:LEC) presented the lowest value of both moduli of G’ and G” during the frequency sweep. The biscuits formulated with commercial margarine (B_MR) registered a hardness of 28.74 N. Samples with oleogels showed a specific tenderness for tender dough products, thus being suitable for this type of product (11.22–20.97 N).

The advanced biochemical characterisation of green, red lentil and wheat flours was performed by assessing their folic acid content as well as individual minerals, amino acids, fatty acids and volatile compounds. Moreover, a nutritionally improved wheat–lentil composite flour, with a content of 133.33 μg of folic acid/100 g, was proposed in order to assure the folic acid daily intake (200 μg) for an adult person. The wheat and lentil flours percentages used for the composite were calculated by using the equations for total material balance and folic acid content material balance. Bread was selected as model food for the composite flour due to its high daily intake (~ 250 g day−1) and to its great potential in biofortification. By this algorithm, two composite flours were developed, wheat–green lentil flour (22.21–77.79%) and wheat–red lentil flour (42.62–57.38%), their advanced biochemical characteristics being predicted based on the determined compositions of their constituents. The baking behaviour of the new developed wheat-lentils composite flours with optimised folic acid content was tested. In order to objectively compare the bread samples, texture profile analysis was considered the most relevant test. A good baking behaviour was observed for the wheat–red lentil bread, while for the wheat–green lentil composite flour, encouraging results were obtained.

Elderberry growth phases represent an irreversible process involving a series of biochemical changes that have an extremely important impact on nutritional characteristics. The aim was to assess the impact of genotype and maturity stage on phenolic compounds, antioxidant capacity and mineral profile in Sambucus plants harvested during different growth phases, from green elder flower buds to purple-black elderberries, including pollen, peduncles and seeds. Growth phases proved to have a greater influence compared to varieties. The green buds and flowers of both varieties had a high concentration of quercetin 3-rutinoside, also termed the key compound of the study. It was found that antioxidant activity varied in the following order: blooming elder flower pollen > white elder flower buds > blooming elder flowers. Based on these findings, several novel food ingredients and supplements could be obtained in order to develop innovative health-promoting products.

Hemp flour from Dacia Secuieni and Zenit varieties was added to bread in different proportions (5%, 10%, 15% and 20%) to improve its nutritional properties. The purpose of this paper was to present the advanced nutritional characteristics of these bread samples. The selected varieties of hemp, accepted for human consumption, met the requirements for the maximum accepted level of THC in seeds. The protein content of new products increased from 8.76 to 11.48%, lipids increased from 0.59 to 5.41%, mineral content from 1.33 to 1.62%, and fiber content from 1.17 to 5.84%. Elasticity and porosity decreased from 95.51 to 80% and 78.65 to 72.24%, respectively. K, Mg, Ca, P, Mn and Fe are the main mineral substances in bread with addition of hemp flour from the Dacia Secuieni and Zenit varieties. The total amount of unsaturated fatty acids in the bread samples with hemp flour ranged from 67.93 g/100 g and 69.82 g/100 g. Eight amino acids were identified, of which three were essential (lysine, phenylalanine, histidine). Lysine, the deficient amino acid in wheat bread, increased from 0.003 to 0.101 g/100 g. Sucrose and fructose decreased with the addition of hemp flour, and glucose has not been identified. The amount of yeasts and molds decreased in the first 3 days of storage. Regarding the textural profile, the best results were obtained for the samples with 5% addition. In conclusion, bread with the addition of hemp flour has been shown to have superior nutritional properties to wheat bread.

The advanced characterization of flour from hemp seeds (edible fruits of Cannabis sativa L.) from the Dacia Secuieni and Zenit varieties, compared to wheat flour, was studied in this research. The aim was to present the characterization of 2 varieties, out of the 70 accepted in Europe, for human consumption. The varieties selected from hemp meet the THC level requirement (0.3 or 0.2% of the dry weight of the reproductive part of the female flowering plant) in seeds. Hemp flour was obtained by grinding. The flour samples were evaluated for physicochemical parameters (moisture, crude protein, lipids, ash, crude fiber), the content of micro and macro elements, fatty acids, amino acids, and carbohydrates. The total proteins in hemp flour are found in larger quantities by over 35% compared to wheat flour, and the lipids reach the threshold of 28%. The amount of mineral substances exceeds 3% in hemp flour, and the fibers exceed 26%, compared to 0.61% for wheat flour. The predominant mineral substances were K, Ca, Mg, p, Fe, and Mn. The predominant fatty acids were the unsaturated ones, predominantly being linoleic acid, followed by oleic and gamma-linoleic acid. In the case of amino acids, the highest amount is found in glutamic acid for hemp flours. As for carbohydrates, sucrose is found in the largest amount, followed by glucose and fructose. In conclusion, hemp flours have superior non-traditional characteristics to wheat flour, being a potential raw material for fortifying food or using them as such, having beneficial effects of consumption on the proper functioning of the human body.

Samples from ‘Stanley’, ‘Vânăt de Italia’ and ‘Tuleu Gras’ plum cultivars were collected from two different positions of the tree crown (i.e., inside, and periphery of the crown) at six different harvesting times, starting with the phase when plum fruits were the size of a bean until they reached full maturity at 21 days intervals. The main phytochemicals of plum skin during fruit development were analyzed. Total polyphenols from plum skin showed variations throughout the fruit growth (200.6 to 1244.5 mg GAE 100g-1), a relatively ascending trend being noticed. For ‘Stanley’ DPPH-Scavenging Activity, statistically insignificant differences (p > 0.05), with values between 47.4% and 51.5%, were found, similar trends being observed for ‘Vânăt de Italia’ and ‘Tuleu Gras’. The total flavonoid content in the analyzed plum fruits statistically significantly decreased (p < 0.05) from fructification to ripening for ‘Stanley’ and ‘Tuleu Gras’. On the other hand, variations were registered for ‘Vânăt de Italia’ cultivar which had the highest flavonoid content on the sixth harvesting phase. Anthocyanin content accumulated in ‘Vânăt de Italia’ plum peel showed increasing values during fruit development, regardless of the harvesting phase, variety or position, while a slightly decreasing trend was found for ‘Stanley’ and ‘Tuleu Gras’ varieties. The largest quantity of total chlorophyll (287.4 µg g-1) was found in the fructification phase, followed by a continuous decrease until ripening, whatever the variety or crown position.