Salar de Atacama is one of the largest global reservoirs of natural lithium brines (mean lithium concentration = 1,500 ppm), enabling Chile to be a leading producer of lithium products. This large salar (3,000 km2), located in the Atacama Desert at 2,300 m above sea level, is dominated by microorganisms; however, little is known about the microbes present in the brines associated with this economically important mining process. Here we study lithium as a modulator of microbial richness and diversity in brines representing natural conditions (34.7% salinity) and conditions prior to lithium production with a concentrated brine (55.6% salinity). Brines only supported a single archaeal family (Halobacteriaceae): natural brines included the archaeal genera Halovenus, Natronomonas, Haloarcula, and Halobacterium. Concentrated brines included the archaeal genera Halovenus, Halobacterium, and Halococcus. The most abundant bacterial families in natural brine were Rhodothermaceae and Staphylococcaceae; Xanthomonadaceae dominated the bacterial community in the concentrated brine. A comparison of entire microbial community (Archaea and Bacteria) revealed that only seven operational taxonomic units were shared between samples, all of which were Archaea. Further, our results showed that Bacteria were phylogenetically more diverse and rich in the concentrated brine, while archaeal diversity was maximized in the natural brine. The concentrated lithium brines of the Salar de Atacama represent one of the most saline environments described to date (dominated by LiCl). We suggest that elevated concentrations of lithium could greatly modulate microbial diversity and give insights into the adaptive biology of microorganisms required to cope with extremely high concentrations of salts that extend beyond that of NaCl, a far more commonly studied salt.
A membrane electrodialysis process was tested for obtaining battery grade lithium hydroxide from lithium brines. Currently, in the conventional procedure, a brine with Li+ 4–6 wt% is fed to a process to form lithium carbonate and further used to produce lithium hydroxide. The disadvantages of this process are its high cost due to several stage requirement and the usage of lime, causing waste generation. The main objective of this work is to demonstrate the feasibility of obtaining battery grade lithium hydroxide monohydrate, avoiding production of lithium carbonate. A laboratory cell was constructed to study electrochemical kinetics and determine energetic parameters. The effects of current density, electrode material, electrolyte concentration, temperature and cationic membrane (Nafion 115 and Nafion 117) on cell performance were determined. Tests showed that a current density of 1200 A/m2 and temperatures between 75–85 °C allow reduced specific electricity consumption (SEC) (7.25 kWh/kg LiOH). A high purity product is obtained at temperatures below 75 °C, with a Nafion 117 membrane and low electrolyte concentration. Resulting key electrochemical data would enable a pilot-scale process implementation to obtain lithium compounds.
The literature shows that inorganic phase change materials (PCM) have been very seldom microencapsulated, so this study aims to contribute to filling this research gap. Bischofite, a by-product from the non-metallic industry identified as having good potential to be used as inorganic PCM, was microencapsulated by means of a fluidized bed method with acrylic as polymer and chloroform as solvent, after compatibility studies of both several solvents and several polymers. The formation of bischofite and pure MgCl2·6H2O microcapsules was investigated and analyzed. Results showed an efficiency in microencapsulation of 95% could be achieved when using 2 min of fluidization time and 2 kg/h of atomization flow. The final microcapsules had excellent melting temperatures and enthalpy compared to the original PCM, 104.6 °C and 95 J/g for bischofite, and 95.3 and 118.3 for MgCl2·6H2O.
The objective of this work was to evaluate obtaining LiOH directly from brines with high LiCl concentrations using bipolar membrane electrodialysis by the analysis of Li+ ion transport phenomena. For this purpose, Neosepta BP and Fumasep FBM bipolar membranes were characterized by linear sweep voltammetry, and the Li+ transport number in cation-exchange membranes was determined. In addition, a laboratory-scale reactor was designed, constructed, and tested to develop experimental LiOH production tests. The selected LiCl concentration range, based on productive process concentrations for Salar de Atacama (Chile), was between 14 and 34 wt%. Concentration and current density effects on LiOH production, current efficiency, and specific electricity consumption were evaluated. The highest current efficiency obtained was 0.77 at initial concentrations of LiOH 0.5 wt% and LiCl 14 wt%. On the other hand, a concentrated LiOH solution (between 3.34 wt% and 4.35 wt%, with a solution purity between 96.0% and 95.4%, respectively) was obtained. The results of this work show the feasibility of LiOH production from concentrated brines by means of bipolar membrane electrodialysis, bringing the implementation of this technology closer to LiOH production on a larger scale. Moreover, being an electrochemical process, this could be driven by Solar PV, taking advantage of the high solar radiation conditions in the Atacama Desert in Chile.