Biomass is gaining increased attention as a sustainable and low-cost hard carbon (HC) precursor. However, biomass properties are often unexplored and unrelated to HC performance. Herein, we used pine, beechwood, miscanthus, and wheat straw precursors to synthesize HCs at 1000 °C, 1200 °C and 1400 °C by a two-steps pyrolysis treatment. The final physicochemical and electrochemical properties of the HC evidenced dissimilar trends, mainly influenced by the precursor’s inorganic content, and less by the thermal treatment. Pine and beechwood HCs delivered the highest reversible capacity and coulombic efficiency (CE) at 1400 °C of about 300 mAh·g−1 and 80%, respectively. This performance can be attributed to the structure derived from the high carbon purity precursors. Miscanthus and wheat straw HC performance was strongly affected by the silicon, potassium, and calcium content in the biomasses, which promoted simultaneous detrimental phenomena of intrinsic activation, formation of a silicon carbide phase, and growth of graphitic domains with temperature. The latter HCs delivered 240–200 mAh·g−1 of reversible capacity and 70–60% of CE, respectively, at 1400 °C. The biomass precursor composition, especially its inorganic fraction, seems to be a key parameter to control, for obtaining high performance hard carbon electrodes by direct pyrolysis process.
A study was conducted to investigate the parameter that has influence on steam gasification kinetics between the biomass type and char preparation. Thermogravimetric analysis (TGA) was carried out on steam gasification of seven biomass samples as well as chars from three of these samples. Chars were prepared using three different sets of low heating rate (LHR) pyrolysis conditions including temperature and biomass bed geometry. It was shown by a characteristic time analysis that these pyrolysis conditions were not associated with a chemical regime in a large amount of devices. However, it has been shown experimentally that conditions used to prepare the char had a much lower influence on steam gasification kinetics than the biomass type.
23 November 2023 in Biomass Conversion and Biorefinery
The distribution of inorganic elements between solid and liquid phases during biomass hydrothermal carbonization (HTC) is a poorly investigated topic despite its importance for process optimization. To fill in this gap, the distribution of inorganic elements and their forms were determined for three agro-food waste feedstocks converted at HTC temperatures of 180, 220, and 260 °C in 12 h. Satisfactory balances were achieved, with values between 80 and 92% for C and N, and 80 and 110% for most inorganic elements. At 180 °C, over 90% of P, Mg, Ca, K, Na, and Mn were removed from hydrochars whatever feedstock. At higher temperatures, P, Mg, Ca, and Mn were partly reincorporated into hydrochars (between 7 and 53%), possibly due to the formation of insoluble precipitates, while K and Na remained in the liquid. On the opposite, some minor elements, Cu and Al, remained in the hydrochars, whatever temperature. Si showed different removal behaviors according to feedstock and temperature. These results show the possibility of optimizing the removal of inorganic elements from hydrochars using different temperatures.