GRATEAU Maguelone

Mrs. GRATEAU Maguelone

CEA Grenoble, France
orcid

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2015 in Biomass and Bioenergy
Verified
Journal Article
Closed access
CHCéline Hognon
Céline Hognon
FDFlorian Delrue
Florian Delrue
JTJonathan Texier
Jonathan Texier
GMGRATEAU Maguelone
GRATEAU Maguelone
STSébastien Thiery
Sébastien Thiery
ARAnne Roubaud
Anne Roubaud

1 July 2014 in Bioresource Technology
Verified
Journal Article
Closed access
CHCéline Hognon
Céline Hognon
CDCapucine Dupont
Capucine Dupont
GMGRATEAU Maguelone
GRATEAU Maguelone
FDFlorian Delrue
Florian Delrue

15 August 2018 in Energies
Verified
Journal Article
Open access
PDF file
TDTilia Dahou
Tilia Dahou
FDFrançoise Defoort
Françoise Defoort
STSébastien Thiéry
Sébastien Thiéry
GMGRATEAU Maguelone
GRATEAU Maguelone
MCMatthieu Campargue
Matthieu Campargue
CDCapucine Dupont
Capucine Dupont
A study was conducted to investigate the parameter that has influence on steam gasification kinetics between the biomass type and char preparation. Thermogravimetric analysis (TGA) was carried out on steam gasification of seven biomass samples as well as chars from three of these samples. Chars were prepared using three different sets of low heating rate (LHR) pyrolysis conditions including temperature and biomass bed geometry. It was shown by a characteristic time analysis that these pyrolysis conditions were not associated with a chemical regime in a large amount of devices. However, it has been shown experimentally that conditions used to prepare the char had a much lower influence on steam gasification kinetics than the biomass type.

1 April 2019 in Journal of Environmental Management
Verified
Journal Article
Closed access
María González MartínezMaría González Martínez
María González Martínez
CDCapucine Dupont
Capucine Dupont
DPDenilson da Silva Perez
Denilson da Silva Perez
LMLuis Míguez-Rodríguez
Luis Míguez-Rodríguez
GMGRATEAU Maguelone
GRATEAU Maguelone
Christophe GourdonChristophe Gourdon
Christophe Gourdon

26 November 2021 in Metals
Verified
Journal Article
Open access
PDF file
HDHary Demey
Hary Demey
ERElvira Rodriguez-Alonso
Elvira Rodriguez-Alonso
ELElie Lacombe
Elie Lacombe
GMGRATEAU Maguelone
GRATEAU Maguelone
NJNicolas Jaricot
Nicolas Jaricot
TMThierry Melkior
Thierry Melkior
Torrefaction of almond shells and olive stones, which are typically considered agricultural waste in the southern regions of the European Union, was investigated in this work for application as reducing agents in the metallurgical industry. Four different temperatures were tested: 250, 280, 300 and 350 °C. The evolution of the solid yields with the temperature was determined with TGA measurements. This showed that the duration of torrefaction should not exceed 45 min. The kinetic profiles were successfully fitted using the pseudo-first-order rate equation (PFORE). Then, torrefaction for 45 min was systematically carried out at every temperature and for each resource in a laboratory-scale batch device. The raw and torrefied biomasses were characterized using proximate, ultimate and calorific analyses. The carbon/oxygen ratio and the heating values were increased as a result of the torrefaction severity (from 20 MJ/kg for both raw biomasses to 30 MJ/kg at 350 °C). The highest mass losses were obtained at the highest temperature (67.35 and 65.04 %w for almond shells and olive stones, respectively, at 350 °C). The fixed carbon value also increased, being higher than 67 %w for torrefaction at 350 °C. The large-scale torrefaction at 350 °C (45 min) of these biomasses was carried out in a continuous pilot plant. The solids were characterized as well, and their properties were close to those of the biomasses torrefied in the laboratory-scale batch reactor under the same conditions. This thermal treatment provided biochars with all the required properties to be used as reducing materials in metallurgy.

18 July 2020 in Energies
Verified
Journal Article
Open access
PDF file
SVSylvie Valin
Sylvie Valin
SRSerge Ravel
Serge Ravel
PVPhilippe Pons de Vincent
Philippe Pons de Vincent
STSébastien Thiery
Sébastien Thiery
HMHélène Miller
Hélène Miller
GMGRATEAU Maguelone
GRATEAU Maguelone
The aim of this work is to investigate the fluidised bed gasification of several pure and blended feedstock prepared in the form of pellets: oak bark, two bark/wheat straw blends (85/15 and 50/50 wt%) and lignin residue remaining from bioethanol production. Gasification conditions were defined to be representative of dual fluidised bed ones (steam gasification at 850 °C, followed by air combustion of the char). The cold gas efficiency (77–81%), gas composition and tar content (0.9–2.3 g/kgdaf) are close for the gasification of bark and the two bark/wheat straw blends. For lignin residue, the cold gas efficiency is lower (71%), and the tar content is 9.1 g/kgdaf. The agglomeration propensity is much higher for lignin residue than for the other feedstock. This was put into evidence with in-bed temperature measurements at different levels, and confirmed with post-test size screening of the bed material particles. The 50/50 wt% bark/wheat straw blend seems to undergo defluidisation in combustion, however followed by refluidisation of the bed. These findings were also well correlated with a predictive model for defluidisation.