Background: Biotechnologically produced microbial lipids are of interest as potential alternatives for crude and plant oils. Their lipid profile is similar to plant oils and can therefore be a substitute for the production of biofuels, additives for food and cosmetics industry as well as building blocks for oleochemicals. Commercial microbial lipids production, however, is still not profitable and research on process optimization and cost reduction is required. This study reports on the process optimization using glucose or xylose with the unconventional oleaginous yeast Saitozyma podzolica DSM 27192 aiming to reduce the applied carbon source amount without sacrificing lipid productivity. Results: By optimizing the process parameters temperature and pH, lipid productivity was enhanced by 40%. Thereupon, by establishing a two-phase strategy with an initial batch phase and a subsequent fed-batch phase for lipid production in which a constant sugar concentration of about 10 g/L was maintained, resulted in saving of ~ 41% of total glucose and ~ 26% of total xylose. By performing the automated continuous sugar feed the total sugar uptake was improved to ~ 91% for glucose and ~ 92% for xylose and thus, prevented waste of unused carbon source in the cultivation medium. In addition, reduced glucose cultivation resulted in to 28% higher cell growth and 19% increase of lipid titer. By using xylose, the by-product xylonic acid was identified for the first time as by-product of S. podzolica. Conclusions: These findings provide a broad view of different cultivation process strategies with subsequent comparison and evaluation for lipid production with S. podzolica. Additionally, new biotechnological characteristics of this yeast were highlighted regarding the ability to produce valuable organic acids from sustainable and renewable sugars.

Syngas, the product of biomass gasification, can play an important role in moving towards the production of renewable chemical commodities, by using acetogenic bacteria to ferment those gaseous mixtures. Due to the complex and changing nature of biomass, the composition and the impurities present in the final biomass-derived syngas will vary. Because of this, it is important to assess the impact of these factors on the fermentation outcome, in terms of yields, productivity, and product formation and ratio. In this study, Clostridium ljungdahlii was used in a fed-batch fermentation system to analyze the effect of three different biomass-derived syngases, and to compare them to equivalent, clean syngas mixtures. Additionally, four other clean syngas mixtures were used, and the effects on product ratio, productivity, yield, and growth were documented. All biomass-derived syngases were suitable to be used as substrates, without experiencing any complete inhibitory effects. From the obtained results, it is clear that the type of syngas, biomass-derived or clean, had the greatest impact on product formation ratios, with all biomass-derived syngases producing more ethanol, albeit with lesser total productivity.

The fermentation of synthesis gas, or syngas, by acetogenic bacteria can help in transitioning from a fossil-fuel-based to a renewable bioeconomy. The main fermentation products of Clostridium ljungdahlii, one of such microorganisms, are acetate and ethanol. A sensitive, robust and reproducible system was established for C. ljungdahlii syngas fermentation, and several process parameters and medium components (pH, gas flow, cysteine and yeast extract) were investigated to assess its impact on the fermentation outcomes, as well as real time gas consumption. Moreover, a closed carbon balance could be achieved with the data obtained. This system is a valuable tool to detect changes in the behavior of the culture. It can be applied for the screening of strains, gas compositions or media components, for a better understanding of the physiology and metabolic regulation of acetogenic bacteria. Here, it was shown that neither yeast extract nor cysteine was a limiting factor for cell growth since their supplementation did not have a noticeable impact on product formation or overall gas consumption. By combining the lowering of both the pH and the gas flow after 24 h, the highest ethanol to acetate ratio was achieved, but with the caveat of lower productivity.

The fermentation of synthesis gas, or syngas, which consists mainly of CO, CO₂ and H₂ by acetogenic bacteria has the potential to help in transitioning from a fossil-fuel-based to a renewable bio-economy. Clostridium ljungdahlii, one of such microorganisms, has as main fermentation products acetate and ethanol. Multiple research efforts have been directed towards understanding how the metabolism and the product formation of this, and other acetogenic bacteria, can be directed towards increasing productivities and yields; nonetheless, transferring those findings to a particular set-up can prove challenging. This study used a well-established and robust fed-batch fermentation system with C. ljungdahlii to look into the effects of different fermentation pH profiles, gas flow, and the supplementation with additional yeast extract or cysteine on growth, product formation ratios, yields, and productivities, as well as gas consumption. Neither yeast extract nor cysteine supplementation had a noticeable impact on cell growth, product formation or overall gas consumption. The lowering of the pH proved mainly detrimental, with decreased productivities and no improvement in ethanol ratios. The most notable shift towards ethanol was achieved by the combination of lowering both the pH and the gas flow after 24 h, but with the caveat of lower productivity. The obtained results, unexpected to some extent, highlight the necessity for a better understanding of the physiology and the metabolic regulation of acetogenic bacteria in order for this process to become more industrially relevant.