An 8.8-mW, low-noise, 40.5-GHz frequency synthesizer is proposed. The synthesizer system consists of a subsampling phase-locked loop (SSPLL) with 100-MHz crystal reference, a 900-MHz high-frequency-reference (HFR) PLL, and a novel subsampling lock detector (SSLD). The SSLD keeps monitoring the locking status of the SSPLL by sampling the SSPLL output with the HFR 900-MHz reference and automatically controls the SSPLL for frequency acquisition if it loses lock or locks to a wrong 100-MHz harmonic. This is done without using a power-consuming divider-based frequency-locked loop in conventional SSPLL. Due to the relatively low-frequency operation and moderate noise requirement of HFR, as well as the low-power SSLD, the proposed system achieves low power consumption and jitter simultaneously. The measured results show 8.8-mW power consumption and 228-fs rms jitter with in-band and out-band phase noises of -96.6 dBc/Hz at a 1-MHz offset and -106.9 dBc/Hz at a 10-MHz offset, respectively.
5 January 2021 in IEEE Transactions on Circuits and Systems II: Express Briefs
A current mismatch compensation structure for SSPLL charge pump (CP) is proposed and implemented in a low-power 40.5GHz frequency synthesizer. Transistor's channel-length-modulation (CLM) effect induces SSPLL loop gain distortion and decreases VCO control voltage ( V ctrl ) locking range (LR). The proposed compensated CP uses feedback loops to cancel the CLM effect and hence extends V ctrl LR from 0.50V to 0.75V under a 1V supply, without degrading SSPLL noise performance. As a result of the more efficient use of V ctrl range, VCO capacitor bank setup number is reduced from 10 to 7 to cover the same 10% total tuning range. Due to the low-power dividerless structure with sub-sampling lock detector (SSLD) for frequency acquisition, the SSPLL with the proposed compensated CP consumes only 9.5mW power with 192fs RMS jitter.
25 April 2023 in IEEE Journal of Solid-State Circuits
A 110-mW 39-GHz Doppler radar front end in 65-nm CMOS for displacement and vibration sensing is proposed. Conventional Doppler radar suffers from detection nulls, at which the receiver detection gain drops to zero. Quadrature demodulation for either carrier frequency or intermediate frequency (IF) is necessary to alleviate nulls but still induces nonlinear detection gain that needs to be compensated through digital signal processing (DSP). In this article, a Doppler radar topology is proposed to achieve ultrahigh displacement range accuracy and sensitivity and to eliminate detection nulls without using quadrature demodulation. An edge-driven phase demodulator (EDPD) processes the rectified square-wave intermediate signal and converts displacement/vibration to a true-dc/baseband signal with a constant gain. Coherent demodulation and signal generation through common-referenced subsampling phase-locked loops (SSPLLs) allow the radar to achieve 4- $\mu$ m static range accuracy and 39-nm vibrational (at 10 kHz) range sensitivity in measurement.
A 40.5 GHz sub-sampling phase-locked loop (SSPLL) with only 9.6 mW power consumption is presented. The proposed Sub-Sampling Lock Detector (SSLD) samples the output signal with on-chip generated 900 MHz reference, and can automatically detect and rectify the unlock or locked-to-wrong-harmonic states. This is done without using traditional power-consuming divider-based frequency-locked loop (FLL). The proposed SSPLL hence achieves low power, low in-band phase noise and robust operation simultaneously.
A 310GHz sub-harmonic self-oscillating mixer (SHSOM) with on-chip LO generation is demonstrated in this paper. The mixer consists of four Clapp oscillators that are differentially coupled to the adjacent one. Two patch antennas deliver the differential RF signal to the mixer/oscillator and with the large LO swings at the transistor terminals, high conversion gain is achieved. By controlling the phase shift of the RF signal between gate and drain, the conversion gain is boosted. Using a 65nm CMOS technology, the prototype of the SHSOM achieves 16.8 dB conversion loss and 21.3 dB noise Figure at 310GHz. The 3-dB IF bandwidth is more than 8GHz and DC power consumption is around 55mW in total.