Arrhenius parameters for backbiting (bb), mid-chain radical propagation (pm) and β-scission in n-butyl acrylate radical polymerization are determined based on pulsed laser polymerization (PLP) inflection point data derived from size exclusion chromatography (SEC) analysis with limited monomer conversion. Laser pulse frequencies ranging from 1 to 60 Hz are only needed as bulk data are complemented with solution data (solvent: butyl propionate) to increase parameter sensitivity and to lower parameter correlations, as confirmable by the calculation of the correlation matrix, without inducing a kinetically significant solvent effect. ‘Low’ temperature (303–323 K) and ‘high temperature (383–413 K) PLP experiments are carried out to further minimize parameter correlations by a step-wise parameter estimation. The former experiments are used for the estimation of the Arrhenius parameters for backbiting and mid-chain radical propagation, with literature Arrhenius parameters for end-chain propagation as input. The latter experiments consider the former Arrhenius parameters as input to reliably estimate the remaining Arrhenius parameters for β-scission. In agreement with literature data, Ea(kbb) is determined as (30.6 ± 5.4) kJ mol−1, ln A(kbb s−1) as 17.8 ± 2.1, Ea(kp,m) as (30.1 ± 9.7) kJ mol−1, and ln(kp,m L mol−1 s−1) as 14.5 ± 3.7. Additionally, Ea(kβ) is estimated as (81.1 ± 18.2) kJ mol−1 and ln A(kβ s−1) as 29.7 ± 5.5, which indicates a higher relevance of β-scission at temperatures around 400 K as previously expected.
14 September 2018 in Reaction Chemistry & Engineering
A novel method to estimate the β-scission rate coefficient (kβ) in radical polymerization of acrylates is introduced, provided that the backbiting and tertiary propagation rate coefficient have already been determined at sufficiently low temperatures at which β-scission is negligible (≪350 K). The method relies on the sensitivity of kβ upon a change of the pulse laser frequency (≪200 Hz) under isothermal pulsed laser polymerization (PLP) conditions in the temperature range between ca. 350 and 415 K, leading to a sufficient variation of the times scales of the radicals involved. These observations are not significantly influenced by macropropagation and thermal self-initiation, as respectively confirmed by in silico testing and experimental data. Solution inflection point data (e.g. solvent butyl propionate) are needed in the lower temperature range (350–410 K), whereas bulk inflection point data suffice in the higher temperature range (410–415 K). The proposed method leads to an estimated kβ value of (4.26 ± 1.8) × 102 s−1 at 413 K with bulk PLP data, suggesting a high propensity of macromonomer formation in acrylate polymerization under high temperature radical polymerization conditions, exceeding the previously suggested levels (kβ = 6 × 100–1.45 × 102 s−1).
30 April 2014 in Industrial & Engineering Chemistry Research