Ali Karami Horestani

Dr. Ali Karami Horestani


Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2014 in Electronics Letters
Verified
Journal Article
Open access
PDF file
AHAli Karami Horestani
Ali Karami Horestani
JNJ. Naqui
J. Naqui
DADerek Abbott
Derek Abbott
CFC. Fumeaux
C. Fumeaux
Ferran MartinFerran Martin
Ferran Martin
A two‐dimensional displacement and alignment sensor is proposed based on two open‐ended transmission lines, each loaded with a split ring resonator (SRR). In this arrangement, the depth of resonance‐induced notches in the reflection coefficients can be used to sense a displacement of the loading SRRs in two orthogonal directions. Since the operation principle of the sensor is based on the symmetry properties of SRR‐loaded transmission lines, the proposed sensor benefits from immunity to variations in ambient conditions. More importantly, it is shown that in contrast to previously published metamaterial‐inspired two‐dimensional displacement and alignment sensors, the proposed sensor can be operated at a single fixed frequency. The concept and simulation results are validated through measurement.

23 April 2015 in Sensors
Verified
Journal Article
Open access
PDF file
JNJordi Naqui
Jordi Naqui
JCJan Coromina
Jan Coromina
AHAli Karami Horestani
Ali Karami Horestani
CFChristophe Fumeaux
Christophe Fumeaux
Ferran MartinFerran Martin
Ferran Martin
In this paper, angular displacement and angular velocity sensors based on coplanar waveguide (CPW) transmission lines and S-shaped split ring resonators (S-SRRs) are presented. The sensor consists of two parts, namely a CPW and an S-SRR, both lying on parallel planes. By this means, line-to-resonator magnetic coupling arises, the coupling level being dependent on the line-to-resonator relative angular orientation. The line-to-resonator coupling level is the key parameter responsible for modulating the amplitude of the frequency response seen between the CPW ports in the vicinity of the S-SRR fundamental resonance frequency. Specifically, an amplitude notch that can be visualized in the transmission coefficient is changed by the coupling strength, and it is characterized as the sensing variable. Thus, the relative angular orientation between the two parts is measured, when the S-SRR is attached to a rotating object. It follows that the rotation angle and speed can be inferred either by measuring the frequency response of the S-SRR-loaded line, or the response amplitude at a fixed frequency in the vicinity of resonance. It is in addition shown that the angular velocity can be accurately determined from the time-domain response of a carrier time-harmonic signal tuned at the S-SRR resonance frequency. The main advantage of the proposed device is its small size directly related to the small electrical size of the S-SRR, which allows for the design of compact angular displacement and velocity sensors at low frequencies. Despite the small size of the fabricated proof-of-concept prototype (electrically small structures do not usually reject signals efficiently), it exhibits good linearity (on a logarithmic scale), sensitivity and dynamic range.

27 June 2016 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
AHAli Karami Horestani
Ali Karami Horestani
ZSZahra Shaterian
Zahra Shaterian
JNJordi Naqui
Jordi Naqui
Ferran MartinFerran Martin
Ferran Martin
CFChristophe Fumeaux
Christophe Fumeaux
This paper proposes a compact reconfigurable (bandstop/bandpass) and frequency-tunable structure based on S-shaped split-ring resonators (S-SRRs). It is known that an S-SRR coupled to a coplanar waveguide (CPW) provides a stopband in the transmission characteristic of the line. It is shown here that this behavior of the S-SRR can be switched between fundamental resonance and second harmonic response by introduction of a p-i-n diode in the center segment of the S-SRR. Alternatively, if the S-SRR is loaded with a varactor diode instead of a switch, the frequency of the stopband can be continuously tuned from the S-SRRs fundamental resonance frequency to its second harmonic. Furthermore, it is shown that if a pair of shunt p-i-n diodes are introduced across the slots of the host CPW, the structure can be reconfigured from a bandstop to a bandpass structure. Thus, the proposed resonator structure can be used as the building block of reconfigurable (bandstop/bandpass) filters with tunable operating frequency. Finally, to demonstrate a practical application of the proposed structure, an ultrawideband antenna with a tunable band notch is designed and experimentally validated.

27 April 2020 in IEEE Sensors Journal
Verified
Journal Article
Closed access
AHAli Karami Horestani
Ali Karami Horestani
ZSZahra Shaterian
Zahra Shaterian
Ferran MartinFerran Martin
Ferran Martin
This paper presents a novel rotation sensor based on the concept of cross-polarized excitation of split ring resonators (SRRs). The structure of the proposed sensor which is quite simple and as a result is low cost, involves a slotline loaded with a rotatable SRR. In this configuration, when the symmetry plane of the loading SRR is orthogonal to the orientation of the slotline, the reflection coefficients from the two ports of the slotline are in phase. However, if the symmetry of the structure is broken by the rotation of the loading SRR, a phase difference between the two reflection coefficients is observed. Therefore, a rotation angle up to 180° can be sensed by measuring the phase difference between the reflection coefficients. Furthermore, it is demonstrated that introducing a flag resonator with the same principle of operation can extend the dynamic range of the proposed sensor to full 360°. A prototype of the proposed sensor is designed and fabricated and its principle of operation and wide dynamic range are validated numerically and experimentally.

7 June 2024 in IEEE Access
Verified
Journal Article
Open access
Mirko MagarottoMirko Magarotto
Mirko Magarotto
FSFatemeh Sadeghikia
Fatemeh Sadeghikia
Luca SchenatoLuca Schenato
Luca Schenato
Davide RoccoDavide Rocco
Davide Rocco
MSMarco Santagiustina
Marco Santagiustina
ACAntonio-Daniele Capobianco
Antonio-Daniele Capobianco
This paper aims to comprehensively review the literature on Gaseous Plasma Antennas (GPAs). These innovative devices transmit electromagnetic (EM) signals through ionized gas, known as plasma, instead of conventional metal structures. GPAs offer distinct advantages over their metallic counter-parts, particularly in performance reconfigurability. The paper begins by evaluating the EM properties of the plasma medium, exploring methodologies for its generation, measurement, and simulation. Subsequently, the prevalent GPA architectures are presented, distinguishing between active and passive concepts based on the plasma’s primary role: either emitting EM signals or manipulating them. Additionally, unconventional GPA implementations, such as explosive or laser-based technologies, are examined. Finally, the paper assesses the most promising applications for leveraging GPAs in various fields.

5 January 2018 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
AHAli Karami Horestani
Ali Karami Horestani
MSMahmoud Shahabadi
Mahmoud Shahabadi
This letter is focused on the design and realization of balanced bandpass filters (BPFs) in gap waveguide technology. The procedure of filter design and resonance-mode selection to achieve the desired differential bandpass behavior with intrinsic deep and wideband common-mode suppression is explained. A third-order differential BPF is designed and fabricated for demonstration. Agreement between the computed and measured results validates the concept and the design procedure.