This study adopted the Rosin-Rammler-Bennett (RRB) equation to model the particle size distribution (PSD) of ground granulated blast furnace slag (GGBFS) and prepared four groups of GGBFS powders with a characteristic particle size De = 8–20 μm and uniformity coefficient n = 0.9–1.4 by means of grading and combining blast furnace slag. In cases both with and without polycarboxylate superplasticizers (PCE), the fluidity and strength of the mortar were measured. The study found that without PCE, the aggregation of GGBFS had a significant negative impact on the mortar fluidity and hardened paste strength. With the addition of PCE, the properties of the mortar mainly depended on two factors, the specific surface area of the GGBFS and the differences in De and n between the GGBFS and Portland cement. At a given specific surface area of GGBFS, high hardened paste strength can be obtained through simultaneously lowering the De and increasing the n.
Concrete permeable brick is a kind of new road pavement material with high permeability and high strength; the mix design is different from ordinary concrete. According to the basic properties of aggregate and workability of fresh permeable brick mixture, a suitable mix design method based on target porosity is introduced. The design method is that the aggregate amount per unit volume of permeable brick is determined according to the aggregate close-packing density first; the theory water consumption is calculated based on the specific absorption of aggregate and hydration of cement second; the amount of cementitious materials is calculated by the apparent density of material, void ratio of aggregate, and target porosity of permeable brick third; and the actual water consumption is determined according to the molding process and workability of mixture finally. The test result indicates that the mix design method of permeable brick is feasible.
The influence of steel fiber and polypropylene fiber mixed on compressive strength of high performance concrete (HPC) was studied. The steel fiber content (0.5%, 1.0%, 1.5%, 2.0%) (volume fraction, the same below), polypropylene fiber content (0.05%, 0.1%, 0.15%, 0.2%) and length (5mm, 6.5mm, 12mm, 18mm) were studied by L16 (45) orthogonal test for 28d ages, the range analysis and variance analysis of the test results are carried out, and the prediction model of compressive strength of hybrid fiber reinforced concrete was established. The results show that: The significant influence factor of concrete compressive strength is the volume fraction of polypropylene fiber, while the length of polypropylene fiber and the volume fraction of steel fiber are not significant; the concrete compressive strength with polypropylene fiber shows negative hybrid effect; The prediction model of compressive strength of hybrid fiber reinforced concrete has high accuracy, and the average relative errors is 2.96%.