Due to the optimum dissolution of the hydroxyl ion, serpentine is positively charged and tends to cover the sulfide mineral surface as a slime coating through electrostatic attraction, which intensively worsens sulfide flotation. To handle this problem, the sodium of polyaspartic acid (PASP) was employed as the selective depressant for the flotation of pyrite from serpentine in this work. Micro-flotation results showed that the fine serpentine of −10 µm could intensively hinder pyrite flotation, with a maximum decrease of about 75.8% in pyrite recovery at pH 9. However, at this pH, pyrite recovery remarkably increased from 20.17% to 92.68% when 15 mg/L PASP was introduced. Zeta potential results depicted that the addition of PASP overcompensated the positive charge on the serpentine surface and rendered it negative, while it had little impact on that of pyrite. Hence, the hetero-coagulation between serpentine and pyrite was broken due to the electrostatic repulsion, which was further confirmed by turbidity results. After that, the adsorption of PAX on the pyrite surface was restored, and the selective flotation of pyrite from serpentine was obtained. XPS analyses revealed that the chelation interaction between the carboxylate groups in PASP and the magnesium cations that remained on the serpentine surface were the main driving forces for the adsorption of PASP on the serpentine surface.

The efficient recovery of fine argentite from polymetallic lead–zinc (Pb–Zn) sulfide ore is challenging. This study investigated nanobubble (NB) adsorption on the argentite surface and its role in enhancing fine argentite flotation using various analytical techniques, including contact angle measurements, adsorption capacity analysis, infrared spectroscopy, zeta potential measurements, turbidity tests, microscopic imaging, scanning electron microscopy, and flotation experiments. Results indicated that the NBs exhibited long-term stability and were adsorbed onto the argentite surface, thereby enhancing surface hydrophobicity, reducing electrostatic repulsion between fine argentite particles, and promoting particle agglomeration. Furthermore, the NBs formed a thin film on the argentite surface, which decreased the adsorption of sodium diethyldithiocarbamate. Microflotation tests confirmed that the introduction of NBs considerably enhanced the recovery of argentite using flotation technology.

At present, the research on flotation separation of cassiterite and gangue minerals is mainly focused on the development of new collectors or depressants, while the research on combined depressants is rare. In this study, the flotation separation of cassiterite and the typical gangue mineral, calcite, was investigated using the metal-inorganic complex depressant AlSS, composed of aluminum sulfate (Al₂(SO₄)₃) and water glass (Na₂SiO₃·4H₂O). The flotation results indicated that, with the assistance of Al³⁺, the inhibition effect of SS (water glass) on calcite is significantly enhanced, while the inhibition effect on cassiterite is almost unchanged. The zeta potential and adsorption measurements proved that the formation of the negatively charged colloidal particles composed of Al_m(OH)_n^3m−n and SiO_m(OH)_n^4−2m−n tended to adsorb on the positively charged calcite surface, inhibiting the adsorption of sodium oleate (NaOL), while the adsorption of the colloidal particles on the negatively charged cassiterite surface is relatively less. The contact angle measurements indicate that the contact angle of cassiterite in the NaOL + AlSS solution is obviously larger than that of calcite, which indicates that cassiterite has better floatability in this system. The X-ray photoelectron spectroscopy (XPS) analysis confirms the Al and Si species are adsorbed on the surface of calcite, but not on the cassiterite. In addition, the adsorption of AlSS on cassiterite and calcite changes the chemical environment on the calcite surface, indicating that the adsorption of AlSS on the mineral surface is more inclined to be through a chemical reaction.

The floatability of fluorite and calcite exhibit similar properties, rendering their flotation separation challenging. Macromolecular polysaccharide reagents containing the polyhydroxyl group have shown broad promising application. The selectivity of polysaccharide is relatively low. In this study, the introduction of Fe³⁺ was employed to enhance the selective adsorption capacity of Pullulan polysaccharide towards fluorite and calcite minerals, thereby achieving effective flotation separation. Furthermore, the mechanism underlying intramolecular interactions was elucidated. The DFT calculation and XPS analysis revealed that the adsorption of Fe³⁺ on the calcite surface was more favorable, leading to the formation of a Ca-O-Fe structure. The MD simulation, XPS analysis, and Zeta potential analysis revealed that the Fe-OH groups on the surface of calcite reacted with the -OH groups in Pullulan and formed bonds, resulting in the formation of a Calcite-Fe-Pullulan structure. This facilitated the attachment of a significant number of Pullulan molecules to the calcite surface. The formation of a hydrophilic layer on the outer surface of calcite by Pullulan, in contrast to the absence of such layer on fluorite’s surface, results in an increased disparity in surface floatability between these two minerals, thereby enhancing the efficiency of flotation separation.

The paper systematically investigated the flotation behavior and interaction mechanisms of andalusite and quartz under sodium dodecyl sulfonate (SDS) through integrated experimental and computational approaches, including zeta potential measurements, Fourier-transform infrared (FTIR) spectroscopy, Materials Studio (MS)-based quantum chemical calculations, and single-mineral flotation tests. The results of zeta potential and infrared spectroscopy analysis indicated that SDS underwent strong chemical adsorption on the surface of andalusite, while the adsorption effect on the surface of quartz was not obvious. MS calculations showed that the {100} surface energy of andalusite was the lowest, and it was the most important dissociation surface. After SDS was adsorbed on the {100} surface of andalusite, the aluminum atoms on the surface of andalusite lost electrons, resulting in a significant increase in the number of positive charges they carried. The activity of oxygen atoms was enhanced, while the number of charges carried by silicon atoms changed relatively little. It was indicated that SDS adsorbed the active sites of Al atoms on the surface of andalusite. The results of the pure mineral flotation test further verified the accuracy of the previous test results, indicating that andalusite and quartz had a good flotation separation effect under the SDS system.