The coagulation–flocculation–sedimentation process is widely used for removal of suspended solids and water turbidity reduction. The most common coagulants used to conduct this process are aluminum sulfate and ferric sulfate. In this paper, the use of Aloe vera as a natural-based coagulant for drinking water treatment was tested. The bio-coagulant was used in two different forms: powder as well as liquid; the latter was extracted with distilled water used as a solvent. The obtained results showed that the use of the natural coagulant (Aloe vera) in both powder (AV-Powder) and liquid (AV-H2O) forms reduced the water turbidity at natural pH by 28.23% and 87.84%, respectively. Moreover, it was found that the use of the two previous forms of bio-coagulant for drinking water treatment had no significant influence on the following three parameters: pH, alkalinity, and hardness. The study of the effect of pH on the process performance using Aloe vera as a bio-coagulant demonstrated that the maximum turbidity removal efficiency accounted for 53.53% and 88.23% using AV-Powder and AV-H2O, respectively, at optimal pH 6.
An enhanced and different method for the active coagulant agent extraction from Moringa Oleifera seeds powder (MOSP) was established and compared to the conventional extraction method in distillate water. In the improved method, MOSP were extracted using sodium chloride as solvent at different concentrations to extract more coagulant agent from Moringa Oleifera and enhance coagulation activity. In this study, MOSP were initially processed and oil content was removed to minimize coagulant concentration usage (MOSP-EO). Moringa Oleifera seeds powder was characterized by both X-ray and FTIR analysis. Ultrasound treatment as well was considered as an additional treatment for MOSP-EO to investigate its effect on coagulant agent extraction process improvement. Coagulation/flocculation experiments were conducted to assess coagulant extraction performance realized through various conditions. The effect of coagulant dosage, solvent concentration and ultrasound exposition duration were investigated for a real effluent of municipal wastewater treatment. Among the three studied NaCl concentrations, 1.0 M was found to be the best solvent concentration for high turbidity removal of more than 97% using 140 mg/L of MOSP-EO compared to extraction in distillate water 88% using 170 mg/L of the same coagulant. NaCl 1.0 M demonstrated the best performance in biochemical oxygen demand (BOD5) removal as well, where more than 98% of municipal wastewater initial BOD5 was eliminated. Mixing MOSP-EO assisted with ultrasound waves at different treatment periods did decrease the active coagulant agent extraction and thus showed its inconvenient for Moringa Oleifera coagulation activity usage.
The present work sheds light on the potentiality of proteins extracted from oak (Quercus robur) leaves to treat both drinking water and industrial oily wastewater. The work was structured in three steps: firstly, oak leaves in powder form were analyzed by FTIR, XRD and SEM, thus showing the presence of proteins acting as bio-coagulants; secondly, an experimental design was conducted. According to the design of experiences based on fractional design (28−4), the highest protein concentration (4.895 mg/g) was obtained for the following operating parameters: no filtration, pH of 12, temperature of 20 °C, stirring speed of 300 rpm, stirring time of 60 min, maceration time of 4 h, centrifugation speed of 400 rpm, centrifugation time of 10 min. Finally, a jar test apparatus was used to study the effects of proteins from oak leaves on the characteristics of both drinking water and industrial oily wastewater. In drinking water, the turbidity was reduced from 15.7 to 4.82 NTU when 0.098 mg/L of oak leaves protein was added, thus satisfying the requirements of the national drinking water standards; whereas, in industrial oily wastewater turbidity, total suspended solids, chemical oxygen demand and organic matter were reduced by 96.87, 89.86, 96.39 and 46.28%, respectively, when 0.538 mg/L of oak leaves protein was added. This study opens new perspectives related to the research and development of organic coagulants applicable to industrial wastewater treatment.
This work emphasizes the efficiency of the response surface design to optimize the parameters affecting the removal of a textile dye—Direct Red 81 (DR-81)—by biosorption on seafood waste, namely, cockleshells (CS). The adsorbent was characterized by X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR), energy-dispersive X-ray spectroscopy (EDX), thermogravimetric analysis (TGA), scanning electron microscopy (SEM), and Brunauer–Emmett–Teller (BET) analysis of surface and pH points of zero charge (pHpzc). A Box–Behnken design (BBD) with three factors was used to optimize the experimental conditions. After the experiment and data analysis, the optimal conditions found were 1 g of adsorbents, 10 mg/L of initial dye concentration, and a pH of 2 in the adsorbate solution, with the highest removal efficiency of 99.98%. The experimental results were analyzed by the ANOVA test, and they demonstrated the acceptability of the quadratic regression model. The adjusted determination coefficient R2 (adj) was equal to 98.82%, indicating an excellent relationship between the predicted and experimental responses. Langmuir isotherms were determined to be the best-fitting model, and the maximum adsorption capacity was 4.65 mg/g. The adsorption process was endothermic and fit the pseudo-second-order model. The negative values of ∆H and ∆S in the thermodynamic research showed that the bio-adsorption technique for the removal of Direct Red 81 is exothermic, spontaneous, and feasible. In addition, the negative value of ∆G indicates that the adsorption mechanism occurs at solid–liquid interfaces with an increasing number of species.