The present status of COVID―19 is analyzed and the end of the disease is forecasted. The peak of the epidemic is different in three regions, Wuhan, Hubei province except Wuhan, and mainland China except Hubei. In two regions except Wuhan, the peak of the epidemic passed ten days ago. If the trend until February 11 does not change, the disease may end by the end of February. In Wuhan, the epidemic reached a peak but the reported number of newly infected patients fluctuates largely. We need to know the reason for the big fluctuation to forecast the end of the disease.
This study reports that thermionic emission can dominate over multi-photon ionization in gold nanoparticles under femtosecond laser irradiation. The brightness of individual particles observed with photoemission electron microscopy increased steeply for laser power above 200 mW, which is reproduced well by the Richardson–Dushman equation. The temperature estimated by fitting the equation is about 1 eV. This high temperature suggests that the laser is absorbed by defects. The difference in brightness among the nanoparticles as large as a few orders of magnitude is attributed to variation in the defect density. The particles having a similar temperature despite exhibiting largely varying brightness levels can be explained by slow energy transfer from the defects to the ambient electron gas. Discussions for interpreting the observed results suggest that thermionic emission can be a useful diagnostic tool for characterizing nanoparticles.
The authors propose that high catalysis of TiO2 nanoparticles (NPs) originates in the generation of excited states in the conduction band, which realize a long lifetime of hot electrons. This paper confirms their claim by observing individual NPs in the femtosecond laser pump-and-probe technique using photoemission-electron-microscopy. The low slope of the power dependence of the brightness of NPs is attributed to thermionic electron emission from an excited state below the vacuum level. An intermediate excited state is required to explain the asymmetrical delay dependence of the brightness enhancement, and the energy position is assigned to 0.78 eV above the conduction band minimum from the laser wavelength for the longest decay time of the brightness enhancement. A lifetime as long as 4 ps for hot electrons of 0.8 eV kinetic energy is observed when resonantly excited by a 760 nm light. The observed lifetime in TiO2 NPs is more than 10 times longer than those in previous papers using single crystals, which supports the authors’ claim.
For effective use of a laser-produced-plasma (LPP) light source, an LPP is desired to emit a narrow spectral peak because the reflection spectrum of multilayer mirrors for guiding emission from the source is very narrow. While a Gd plasma has been studied extensively as an extreme ultraviolet (EUV) light source at around 6.8 nm, where La/B4C multilayer is reported to have a high reflectivity with a bandwidth of about 0.6 %, all previous works using an Nd:YAG laser reported very broad spectra. This paper reports the first narrowing of the 6.8 nm peak in the case of using an Nd:YAG laser to generate a Gd plasma by using a pre-pulse. The best peak narrowing is observed when a pre-formed plasma is heated by a 1064 nm main laser pulse with a duration of 10 ns at the irradiation density of 4x 1011 W/cm2 at a delay time of 50 ns after the pre-pulse irradiation. The observed spectral width of about 0.3 nm is about one fifth of the value for no pre-formed plasma. The peak wavelength of the 6.8 nm band shifted to a longer wavelength side and the peak was broadened both for lower and higher laser irradiation density. It is discussed that this robustness of the peak position of the 6.8 nm Gd peak against temperature change is suitable to achieve a narrow bandwidth from an LPP generated on solid. The observed spectra are compared with those previously reported in various conditions.
The use of any solid material as a fuel and the discharge stability make a laser triggered discharge-produced-plasma (LT-DPP) an attractive light source. Density, size, uniformity, and so on of a fuel control the pinch process by a Lorentz force, and understanding the plasma dynamics in the initial stage is the most important in the LT-DPP study. This work reports how a material for a pinch is supplied and how a laser-produced-plasma (LPP) generated on the electrode behaves before the main discharge current. Our study revealed that the material of a pinch plasma is mainly supplied by laser ablation of a cathode not by current heating of the electrodes. The delay time of a discharge is determined by the velocity of an LPP generated on the cathode, and the traveling velocity of about 1 × 105 m/s of LPP is determined by two factors: the pressure of LPP and acceleration by the electric field. Before the main discharge current starts to flow, two X-ray pulses are generated. The first X-ray pulse is generated on the cathode where a laser is irradiated. The second X-ray pulse is generated on the anode when the LPP generated on the cathode arrives, and the arrival of the LPP triggers the main discharge current. The material for the pinch is not the LPP, but supplied by laser ablation. A faintly bright region appears between electrodes several tens of ns after the start of the main discharge current and this region is slowly imploded and a pinch plasma is formed at the current peak.
A large number of studies have examined the origins of high-catalytic activities of nanoparticles, but very few have discussed the lifetime of high-energy electrons in nanoparticles. The lifetime is one of the factors determining electron transfer and thus catalytic activity. Much of the lifetime of electrons reported in the literature is too short for a high transfer-efficiency of photo-excited electrons from a catalyst to the attached molecules. We observed TiO2 nanoparticles using the femtosecond laser two-color pump-probe technique with photoemission electron microscopy having a 40 nm spatial resolution. A lifetime longer than 4 ps was observed together with a fast decay component of 100 fs time constant when excited by a 760 nm laser. The slow decay component was observed only when the electrons in an intermediate state pumped by the fundamental laser pulse were excited by the second harmonic pulse. The electronic structure for the asymmetry of the pump-probe signal and the origin of the two decay components are discussed based on the color center model of the oxygen vacancy.