Cement provides zonal isolation and mechanical support, and its integrity is critical to the safety and efficiency of the CO2 injection process for geologic carbon storage. This work focuses on interfacial debonding at wellbore interfaces and radial cracking in cement during CO2 injection. It adopts the definition of the energy release rate (ERR) to characterize the propagation of cracks. Based on the finite element method, the proposed model estimates the ERRs of both types of cracks with practical wellbore configurations and injection parameters. Further parametric studies reveal the effects of cement’s mechanical and thermal properties and the crack geometry on crack propagation. Simulation results show that the ERRs of interfacial and radial cracks would surpass 100 J/m2 with typical cement properties. The cement’s thermal expansion coefficient is the most influential factor on the ERR, followed by its Young’s modulus, Poisson’s ratio, and thermal conductivity. The initial sizes and positions of the cracks are also important parameters for controlling crack propagation. Moreover, non-uniform in situ stresses would accelerate crack propagation at the interfaces. These findings are valuable and could help to optimize cement sheath design in order to ensure the long-term integrity of wells for geological carbon storage.
Mixed-mode cooling can effectively reduce the energy consumption of building cooling while satisfying the thermal comfort of occupancy and indoor air quality requirements. This paper predicted the thermal performance and energy-saving potential of an existing Beijing office building (in continental climates) operated in a mixed-mode from April to October. For the natural ventilation mode, the results predicted by simulation were validated with the results of experiments conducted in October 2021 and April 2022. Occupancy thermal comfort of the mixed-mode building was predicted using Predicted Mean Vote (PMV) and adaptive comfort models. The predictions demonstrated acceptable satisfactory thermal comfort for the occupancy. The results showed that the mixed-mode building’s annual cooling energy use is reduced by around 45% compared to the air-conditioned building. In addition, the building’s indoor temperature and velocity distributions were predicted using a Computational Fluid Dynamics (CFD) simulation. The validation showed a satisfactory agreement between CFD simulation and measurement data. It is found from CFD results that cross-ventilation can provide thermal comfort for the occupancy while improving fresh air requirements. The suggested that operational strategies of mixed-mode cooling can be used in office buildings in continental climates. Retrofitting the existing office building can bring a significant amount of energy saving.
Evaluation of the sealing performance of the packer rubber varies according to specific simulation models. This paper aims at revealing the difference between elastic and hyperelastic analyses using the finite element mothed (FEM). The study extracts the hyperelastic parameters of the neo-Hookean, the Mooney-Rivlin, and the Yeoh models from a uniaxial tensile test. Then, the setting process of a mechanical packer is simulated by elastic and hyperelastic calculations. We compare the deformed configuration and the contact stress given by these models. Our results show that the Yeoh model produces the minimum residual sum of squares (RSS) among the hyperelastic models for hydrogenated nitrile butadiene rubber (HNBR). The mooney-Rivlin model has a negative parameter, making the calculation unstable. The linear elastic model fails to simulate the setting process, while the neo-Hookean model overestimates the contact stress. Despite the similar stress distribution, the nonlinear elastic model provides a 17.8% higher contact stress on average than the Yeoh model. A parametric study based on the Yeoh model points out that the sub-thickness of the packer rubber needs an elaborate design. Reducing the sub-thickness could increase the contact stress but decrease the seal length in the force control mode. From an engineering perspective, this study demonstrates that it needs to pay more attention when selecting an appropriate material model and a sound analysis method to evaluate the sealing performance of an oil packer.