High-quality graphene is an especially promising carbon nanomaterial for developing nanofluids for enhancing heat transfer in fluid circulation systems. We report a complete study on few layer graphene (FLG) based nanofluids, including FLG synthesis, FLG-based nanofluid preparation, and their thermal conductivity. The FLG sample is synthesized by an original mechanical exfoliation method. The morphological and structural characterization are investigated by both scanning and transmission electron microscopy and Raman spectroscopy. The chosen two-step method involves the use of thee nonionic surfactants (Triton X-100, Pluronic^® P123, and Gum Arabic), a commercial mixture of water and propylene glycol and a mass content in FLG from 0.05 to 0.5%. The thermal conductivity measurements of the three FLG-based nanofluid series are carried out in the temperature range 283.15–323.15 K by the transient hot-wire method. From a modeling analysis of the nanofluid thermal conductivity behavior, it is finally shown that synergetic effects of FLG nanosheet size and thermal resistance at the FLG interface both have significant impact on the evidenced thermal conductivity enhancement.

The encapsulation of curcumin in micellar caseins (MCs) and the production of powder were performed by spray-drying. Nearly 97% of the curcumin was retained and the yellow powder showed a typical high casein powder morphology. The hygroscopic properties were determined, slight differences reflected less available hydrophobic sites when curcumin was bound to casein, favoring interactions with water in curcumin-enriched MC powders. No difference was detected on the internal MC structure via SAXS. The antioxidant activity of doped-curcumin powder presented 88% of active curcumin. For 60 days at 40 °C storage, the antioxidant activity of curcumin measured by ABTS and FRAP assays was preserved with a percentage of 82 ± 2.0% and 84 ± 1.1%, respectively. Curcumin doped powders presented similar features to classical casein powders (rehydration and gelling abilities). It was demonstrated that curcumin encapsulation in MCs in its powder form helped in protecting its antioxidant activity without influencing the techno-functional properties of MCs. This study allowed the incorporation of curcumin via the MC matrix as an active food ingredient available in a powder state usable as classical milk powder in several food formulations.

The mechanisms of formation of organically modified (phenyl, vinyl, and methyl) silica materials with cubic Pm3̅n and hexagonal p6m periodic mesostructures obtained in one step in the presence of the cetyltrimethylammonium bromide (CTA⁺B) surfactant are reported in this study. Understanding the way these complex materials form is difficult but undoubtedly necessary for controlling the material structure and its properties because of the combined presence of surface organic groups and large surface areas. Here, the mechanism of formation is clarified on the basis of the modeling of time-resolved in situ small angle X-ray scattering (SAXS) experiments, with a specific focus on the micelle evolution during material formation. Their fast self-assembly is followed for the first time with a quick temporal resolution of a few seconds using a third-generation synchrotron radiation source. To better understand the behavior of the complex organic-containing mesostructure, we perform a comparative study with the corresponding organo-free, isostructural materials obtained from three different surfactants (CTA⁺, CTEA⁺, and CTPA⁺) having a constant chain length (C₁₆) and an increasing polar head volume (met-, et-, and prop-). Numerical modeling of SAXS data was crucial to highlighting a systematic sphere-to-rod micellar transition, otherwise undetected, before the formation of the 2D hexagonal phase in both organo-free and organo-containing systems. Then, two different pathways were found in the formation of the cubic Pm3̅n mesostructure: either an ordering transition from concentrated flocs of spherical micelles (from CTEA⁺ or CTPA⁺) for pure TEOS systems or a structural transformation from an intermediate 2D hexagonal mesophase in organosilane systems (from CTA⁺). Combining the comparison between organo-free and organo-containing systems with numerical modeling, we find that the hexagonal-to-cubic phase transition in the organically modified materials seems to be strongly influenced not only by the obvious presence of the organic group but also by the quicker and more massive condensation kinetics of silicate oligomers on the CTA⁺ micellar surface. Finally, quite unexpectedly, we find a wormlike-to-sphere micellar transition in the CTPA⁺ system.