Paste backfill mining is an significant part of green coal mining, which can improve resource utilization and extend the service life of mines. It is important for solving the “three under, one above” mining problem and avoiding industrial wastes such as coal gangue and fly ash that occupy farmland and pollute the environment. To address the difficult filling problem of a fully mechanized top-coal caving face (FMT-CCF), a new method of partial paste backfill mining is herein proposed. First, the partial paste backfill mining method and implementation steps of the FMT-CCF are introduced in detail. Then, the mechanistic model of the roof beam in partial paste backfill mining is established. Then, the filling structural factors on the filling effect of the 42105 FMT-CCF are determined. Dependent on the assay of the migration law of overlying stratum after filling, numerical simulation analysis is used to research the feature effect of the main filling structural factors on the filling effect. Finally, the paste filling rate, filling width, and filling strength suitable for the 42105 FMT-CCF are obtained. When the filling rate reaches 100%, a significant alteration takes place, resulting in the efficient decrease of the overlying rock stress arch shell’s height. As the width of the filling body expands from 10 m at each end to 20 m, the stress arch of the overlying rock experiences maximum reduction, specifically decreasing by approximately 14 m. When the strength of the filling body is greater than 0.4 GPa, the filling effect is better. This study has important guidance and reference significance for the partial paste backfill of FMT-CCF in thick seam mining.

Gob-side entry retaining, also termed as non-pillar mining, plays an important role in saving coal resources, high production and efficiency, extending the service life of mine and improving the investment benefit. Herein, a gob-side entry retaining method involving the use of bag filling material for wall construction is proposed based on the thin seam mining characteristics. First, a gob-side entry retaining mechanical model is established, and the side support resistance of the 8101 working face is calculated. The mechanical properties of the bag material are investigated through experiments, and the construction technology of the gob-side entry retaining approach involving the use of bag filling material for wall construction is introduced. The deformation on the two sides, the roof and floor of the roadway, are simulated via numerical methods and monitored during field tests. The results show a small control range for the deformations and a good roadway retention effect, thereby proving the feasibility of the bag filling material for wall construction. This study provides a reference for the development of gob-side entry retaining mining for thin coal seams.

Rock destruction under high‐temperature conditions is a key issue for nuclear waste treatment projects, underground coal gasification, and improvement of the use of geothermal energy for heating. Therefore, in this study, various methods and techniques were integrated to study the changes in mechanical properties, mineral composition, and microscopic fracture characteristics of Sichuan sandstone treated at 600°C. First, the fracture toughness and indirect tensile strength of untreated sandstones and high‐temperature treated sandstones were tested by the MTS testing machine, and the double‐K model (DKFM) was used to estimate the unstable fracture toughness. Then, the diffraction spectra of sandstone were analyzed with an X‐ray diffractometer to determine the mineral composition change after heat treatment. Finally, the microscopic features of sandstone were observed through a scanning electron microscope (SEM) and optical microscope. The results show the following. (1) There is no significant change in the tensile strength and fracture toughness of Sichuan sandstone treated at 600°C. (2) The brittleness of Sichuan sandstone decreases and the ductility increases after high‐temperature treatment. (3) The unstable fracture toughness value K_un obtained by the double‐K model (DKFM) is significantly larger than the apparent fracture toughness value K_if. (4) After treatment at 600°C, the clay minerals in the sandstone changed significantly. Kaolinite is dehydroxylated to metakaolinite, which may increase the ductility of the rock.