The concept of “high entropy” was first proposed while exploring the unknown center of the metal alloy phase diagram, and then expanded to oxides. The colossal dielectric constant found on the bulk high-entropy oxides (HEOs) reveals the potential application of the high-entropy oxides in the dielectric aspects. Despite the fact that known HEO thin films have not been reported in the field of dielectric properties so far, with the high-entropy effects and theoretical guidance of high entropy, it is predictable that they will be discovered. Currently, researchers are verifying that appropriately increasing the oxygen content in the oxide, raising the temperature and raising the pressure during preparation have an obvious influence on thin films’ resistivity, which may be the guidance on obtaining an HEO film large dielectric constant. Finally, it could composite a metal–insulator–metal capacitor, and contribute to sensors and energy storage devices’ development; alternatively, it could be put into application in emerging thin-film transistor technologies, such as those based on amorphous metal oxide semiconductors, semiconducting carbon nanotubes, and organic semiconductors.
In recent years, significant efforts have been devoted to the research and development of spin-coated Al2O3 thin films, due to their large band gaps, high breakdown voltage and stability at high annealing temperature. However, as the alumina precursor has a large surface energy, substrates need to be treated by plasma before spin coating. Therefore, to avoid the expensive and process-complicated plasma treatment, we incorporated zirconium nitrate into the aluminum nitrate solution to decrease the surface energy of the precursor which improve the spreadability. Then, the electrical performances and the surface morphologies of the films were measured. For comparison, the pure Al2O3 films with plasma treatments were also prepared. As a result, after low temperature annealing (200 °C), the relative dielectric constant of Zr–AlOx spin-coated thin-film MIM (Metal-Insulator-Metal) devices can reach 12 and the leakage current density is not higher than 7.78 × 10−8 A/cm2 @ 1 MV/cm when the concentration of zirconium nitrate is 0.05 mol/L. The Aluminum oxide film prepared by zirconium doping has higher stability and better electrical properties than the pure films with plasma treatments and high performance can be attained under low-temperature annealing, which shows its potential application in printing and flexible electronic devices.