Injection molding has been widely used in the mass production of high-precision products. The finished products obtained through injection molding must have a high quality. Machine parameters do not accurately reflect the molding conditions of the polymer melt; thus, the use of machine parameters leads to erroneous quality judgments. Moreover, the cost of mass inspections of finished products has led to strict restrictions on comprehensive quality testing. Therefore, an automatic quality inspection that provides effective and accurate quality judgment for each injection-molded part is required. This study proposes a multilayer perceptron (MLP) neural network model combined with quality indices for performing fast and automatic prediction of the geometry of finished products. The pressure curves detected by the in-mold pressure sensor, which reflect the flow state of the melt, changes in various indicators and molding quality, were considered in this study. Furthermore, the quality indices extracted from pressure curves with a strong correlation with the part quality were input into the MLP model for learning and prediction. The results indicate that the training and testing of the first-stage holding pressure index, pressure integral index, residual pressure drop index and peak pressure index with respect to the geometric widths were accurate (accuracy rate exceeded 92%), which demonstrates the feasibility of the proposed method.
Conventional methods for assessing the quality of components mass produced using injection molding are expensive and time-consuming or involve imprecise statistical process control parameters. A suitable alternative would be to employ machine learning to classify the quality of parts by using quality indices and quality grading. In this study, we used a multilayer perceptron (MLP) neural network along with a few quality indices to accurately predict the quality of “qualified” and “unqualified” geometric shapes of a finished product. These quality indices, which exhibited a strong correlation with part quality, were extracted from pressure curves and input into the MLP model for learning and prediction. By filtering outliers from the input data and converting the measured quality into quality grades used as output data, we increased the prediction accuracy of the MLP model and classified the quality of finished parts into various quality levels. The MLP model may misjudge datapoints in the “to-be-confirmed” area, which is located between the “qualified” and “unqualified” areas. We classified the “to-be-confirmed” area, and only the quality of products in this area were evaluated further, which reduced the cost of quality control considerably. An integrated circuit tray was manufactured to experimentally demonstrate the feasibility of the proposed method.
4 December 2020 in Journal of Applied Polymer Science
This paper reports a novel hot embossing technique using rapid heating and uniform pressure for replication of microstructures on polymeric substrates. The rapid heating is made possible by a graphene–polymer composite heater that makes use of the exceptional thermal and electrical properties of graphene. The uniform embossing pressure is achieved by using gas as the pressing medium. A heating rate of 14 °C s−1 can be achieved by applying a voltage of 44 V to a heating area of 30 mm × 30 mm. A facility that integrates graphene-based heating and gas-assisted embossing is designed and implemented. Three microstructures, namely, microlens array, V-groove, and microcylinder array, are successfully replicated on three polymeric substrates. The accuracy and uniformity of replication over the area of 50 mm × 50 mm is also confirmed. Furthermore, the thermal cycle time is reduced to less than 30 s. This study proves the great potential of using graphene–polymer composite heaters in gas-assisted micro hot embossing for replication of microstructures for various applications.