We investigate the circuit quantum electrodynamics of anharmonic superconducting nanowire oscillators. The sample circuit consists of a capacitively shunted nanowire with a width of about 20 nm and a varying length up to 350 nm, capacitively coupled to an on-chip resonator. By applying microwave pulses we observe Rabi oscillations, measure coherence times and the anharmonicity of the circuit. Despite the very compact design, simple top-down fabrication and high degree of disorder in the oxidized (granular) aluminum material used, we observe lifetimes in the microsecond range.

Disordered thin films are a common choice of material for superconducting, high impedance circuits used in quantum information or particle detector physics. A wide selection of materials with different levels of granularity are available, but, despite low microwave losses being reported for some, the high degree of disorder always implies the presence of intrinsic defects. Prominently, quantum circuits are prone to interact with two-level systems (TLS), typically originating from solid state defects in the dielectric parts of the circuit, like surface oxides or tunneling barriers. We present an experimental investigation of TLS in granular aluminum thin films under applied mechanical strain and electric fields. The analysis reveals a class of strongly coupled TLS having electric dipole moments up to $30\mathrm{e}\AA$, an order of magnitude larger than dipole moments commonly reported for solid state defects. Notably, these large dipole moments appear more often in films with a higher resistivity. Our observations shed new light on granular superconductors and may have implications for their usage as a quantum circuit material.

Quantum technologies rely heavily on accurate control and reliable readout of quantum systems. Current experiments are limited by numerous sources of noise that can only be partially captured by simple analytical models and additional characterization of the noise sources is required. We test the ability of readout error mitigation to correct noise found in systems composed of quantum two-level objects (qubits). To probe the limit of such methods, we designed a beyond-classical readout error mitigation protocol based on quantum state tomography (QST), which estimates the density matrix of a quantum system, and quantum detector tomography (QDT), which characterizes the measurement procedure. By treating readout error mitigation in the context of state tomography the method becomes largely readout mode-, architecture-, noise source-, and quantum state-independent. We implement this method on a superconducting qubit and evaluate the increase in reconstruction fidelity for QST. We characterize the performance of the method by varying important noise sources, such as suboptimal readout signal amplification, insufficient resonator photon population, off-resonant qubit drive, and effectively shortened T₁ and T₂ coherence. As a result, we identified noise sources for which readout error mitigation worked well, and observed decreases in readout infidelity by a factor of up to 30.

The unusual superconducting properties of granular aluminum oxide have been recently investigated for application in quantum circuits. However, the intrinsic irregular structure of this material requires a good understanding of the transport mechanisms and, in particular, the effect of disorder, especially when patterned at the nanoscale level. In view of these aspects, electric transport and voltage fluctuations have been investigated on thin-film based granular aluminum oxide nanowires, in the normal state and at temperatures between 8 and 300 K. The nonlinear resistivity and two-level tunneling fluctuators have been observed. Regarding the nature of the noise processes, the experimental findings give a clear indication in favor of a dynamic random resistor network model, rather than the possible existence of a local ordering of magnetic origin. The identification of the charge carrier fluctuations in the normal state of granular aluminum oxide nanowires is very useful for improving the fabrication process and, therefore, reducing the possible sources of decoherence in the superconducting state, where quantum technologies that are based on these nanostructures should work.

Microwave circuit electrodynamics of disordered superconductors is a very active research topic spawning a wide range of experiments and applications. For compact superconducting circuit elements, the transition to an insulating state poses a limit to the maximum attainable kinetic inductance. It is, therefore, vital to study the fundamental noise properties of thin films close to this transition, particularly in situations where a good coherence and temporal stability is required. In this paper, we present measurements on superconducting granular aluminum microwave resonators with high normal state resistances, where the influence of the superconductor to insulator phase transition is visible. We trace fluctuations of the fundamental resonance frequency and observe, in addition to a 1/f noise pattern, a distinct excess noise, reminiscent of a random telegraph signal. The excess noise shows a strong dependency on the resistivity of the films as well as the sample temperature but not on the applied microwave power.