HUA CHEN

Dr. HUA CHEN

Institute of Microelectronics CAS
orcid

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 July 2017 in Polymer Chemistry
Verified
Journal Article
Closed access
PDF file
YHYuli Huang
Yuli Huang
HUA CHENHUA CHEN
HUA CHEN
JYJunwei Yang
Junwei Yang
WTWanli Tian
Wanli Tian
WWWeizhi Wang
Weizhi Wang
In this study, we polymerized a 1,4-bis(3-phenylquinoxalin-2-yl)benzene unit with DPP and isoindigo units to produce four new polymers and deeply investigated the influence of DPP and isoindigo units on the semiconductor characteristics, band gap, and orientation properties of these polymers. The semiconductor characteristics were measured through flexible organic field effect transistors OFET fabricated by a homemade desktop 3D printer. The polymer with thiophene-based DDP (P2) exhibits the narrowest band gap, both edge-on & face-on orientation, and the highest mobility up to 0.50 cm2 V−1 s−1. The results also prove our accomplishment of lowering the threshold of fabricating 3D printed OFET devices.

14 August 2020 in Sensors
Verified
Journal Article
Open access
PDF file
HUA CHENHUA CHEN
HUA CHEN
YZYanqing Zhong
Yanqing Zhong
Traditional MEMS gyroscope readout eliminates quadrature error and relies on the phase relationship between the drive displacement and the Coriolis position to accomplish a coherent demodulation. This scheme shows some risk, especially for a mode-matching gyro. If only a slight resonant frequency deviation between the drive and sense mode occurs, a dramatic change in the phase relationship follows, which leads to a wrong demodulation. To solve this, this paper proposes a new readout based on the quadrature error and an auxiliary phase-locked loop (PLL). By tuning the phase shifter in the sense-mode circuit, letting the quadrature error and the carrier of the mixer be in 90° phase alignment, the Coriolis was simultaneously in phase with the carrier. Hence, the demodulation was accomplished. The carrier comes from the PLL output of the drive-mode circuit due to its low jitter and independence of the work mode of the gyro. Moreover, an auxiliary PLL is used to filter the quadrature error to enhance the phase alignment accuracy. Through an elaborate design, a printed circuit board was used to verify the proposed idea. The experimental results show the readout circuit functioned well. The scale factor of the gyro was 6.8 mV/°/s, and the bias instability was 204°/h.

1 January 2016 in IEICE Electronics Express
Verified
Journal Article
Closed access
YZYulin Zhang
Yulin Zhang
HUA CHENHUA CHEN
HUA CHEN
GGGuiliang Guo
Guiliang Guo
YYYuepeng Yan
Yuepeng Yan

1 December 2013 in Electronics Letters
Verified
Journal Article
Open access
PDF file
ZGZhong Gao
Zhong Gao
CLChang Liu
Chang Liu
GGGuiliang Guo
Guiliang Guo
HUA CHENHUA CHEN
HUA CHEN
CLChao Luo
Chao Luo
YYYuepeng Yan
Yuepeng Yan
Theoretically, constant output power and high DC‐to‐RF efficiency cannot be simultaneously achieved by a broadband Class E power amplifier (PA) even if the load network could provide the accurate impedance desired at each frequency point. Such a problem is solved with the presented concept of continuous Class E modes. New demands on the load and corresponding load network topology are discussed to provide a theoretical basis. To verify the feasibility, a prototype PA in TSMC 0.18 μm CMOS process is also presented. In the simulation, it exhibits a maximum output power of 18.7 dBm, a power added efficiency of 64–80% and an output power flattening of 0.5 dB in the frequency range from 360 to 610 M (52% of the central frequency). A comparison between it and a broadband parallel Class E PA implemented under the same conditions is also given.

10 November 2023
Verified
Conference Paper
Closed access
CWChuangping Wen
Chuangping Wen
HUA CHENHUA CHEN
HUA CHEN
CLChang Liu
Chang Liu
XXXiangyang Xing
Xiangyang Xing
Coupled ten-switch inverter is a potential solution for paralleled inverters in medium voltage applications due to the lower cost. However, coupled ten-switch inverter lacks medium vectors, which greatly reduces the vector combinations during parallel operation, the existing methods are no longer applicable. To solve this problem, this paper proposes a modulation strategy without the medium vectors to suppress zero-sequence circulation current (ZSCC), common-mode voltage (CMV), neutral point voltage (NPV) deviation. Based on a three-layer objective switching sequences design, low-CMV vectors are utilized to reduce the CMV, the voltage deviations between two inverters are offset by double vector transpositions to suppress ZSCC, P-type and N-type small vectors are utilized alternately in symmetrical sub-sectors to achieve NPV balance. The effectiveness of the proposed method is verified by simulations.

22 November 2021
Verified
Conference Paper
Closed access
HUA CHENHUA CHEN
HUA CHEN
GLGuoyong Li
Guoyong Li
ZMZhen Meng
Zhen Meng
KLKe Liu
Ke Liu
YYYuepeng Yan
Yuepeng Yan
This paper proposes an ultra-high-gain wideband CMOS transimpedance amplifier (TIA) for driving the MEMS beam resonator with ultrahigh motional resistance. A phase compensator made by a tunable capacitor and two resistors provides a lead phase compensation for the TIA. Moreover, the compensator produces a stable input bias voltage for the inverted-based Cherry Hooper amplifier, whose output bias is stabilized by tunable transistors. The common-gate amplifier uses a high-resistance load resistor to ensure a gain of $80\ \text{dB}\Omega$ , and the Cherry-Hooper amplifier uses a high-g m inverter and a high feedback resistor to provide a gain of 35 dB. A dual power supply of 1.2/1.8 V was used to save power. Based on the $0.18 \mu \mathrm{m}$ CMOS process, the TIA shows a simulated gain of $118\ \text{dB}\Omega$ with a bandwidth of 190 MHz. And the input-referred current noise is 20.9 pA/√Hz, and the power without test buffer is only 0.45 mW. The MEMS oscillator starts up within 0.5 ms with a swing of 1.128 Vp-p, and the phase noise is −96.59 dBc/Hz, 99.2 dBc/Hz at 10 kHz, and 100 kHz offset, respectively.