The multiport dc-ac converter (MPC) connected to photovoltaic (PV)-battery hybrid system has the characteristics of high efficiency and low cost in single stage power conversion. However, it is challenging to achieve common-mode voltage (CMV) reduction in this configuration due to its need for power distribution through redundant vectors. To overcome this limitation, this paper proposes an improved space vector modulation (ISVM) method to reduce the CMV and achieve flexible power distribution. By selecting vectors with lower CMVs, a set of new virtual voltage vectors based on the power control parameter is generated. In addition, to further realize flexible power distribution among PV, battery and load, a new control scheme is proposed to achieve power balance in different operating modes under CMV reduction. The highlight of the method is its ability to achieve power distribution and lower CMV simultaneously. Finally, compared to conventional methods, the simulated and experimental results prove that the proposed method can realize CMV reduction, flexible power control with variable port voltages.
10 October 2023 in IEEE Transactions on Industrial Electronics
Due to the less number of switching devices, a coupled eight-switch converter is an attractive topology for reducing cost in photovoltaic generation systems. Nevertheless, the medium vectors are absent in an eight-switch converter compared to the conventional three-level topology, resulting in an undesired performance for leakage current suppression and neutral point voltage (NPV) balancing with existing methods. To overcome such limitations, this article proposes a modulation method without the medium vectors for leakage current suppression and NPV balancing for eight-switch converters. In order to mitigate the leakage current, except for using the low common-mode voltage (CMV) vectors to reduce the amplitude of the CMV, two pairs of sequences are further designed to lower the transitions of the CMV. Simultaneously, the average switching frequency is reduced and the NPV balance can be achieved by changing between sequences. The effectiveness of the proposed method is verified by simulations and experiments.
7 August 2023 in IEEE Journal of Emerging and Selected Topics in Power Electronics
The five-level converter is a promising topology for industrial applications. In this paper, a novel flying-capacitor (FC) five-level topology with reduced switching devices (RSD-FC5L topology) and its corresponding control scheme are designed. Compared with conventional topologies, the RSD-FC5L topology has a lower total blocking voltage (TBV) and only requires balancing the FC voltages without considering the neutral-point voltage (NPV) control, which reduces the complexity of control technology. To operate the RSD-FC5L topology properly, an improved model predictive control (IMPC) scheme is proposed. Firstly, the space vector diagram is normalized and an easy judgment can realize accurate current tracking. Then, in order to balance the FC voltages, the space vector diagram is re-divided into new candidate hexagons consisting of various vectors. During the entire control process, the cost function is avoided and the weighting factor is eliminated thereby, which further reduces the control complexity. The effectiveness of the proposed topology and IMPC scheme is verified by the simulation and experiment.
22 July 2024 in IEEE Transactions on Power Electronics
Flying-capacitor (FC) five-level topology with lower total blocking voltage is a potential topology in the medium-voltage application. Still, under high modulation indexes, conventional modulation methods cannot guarantee the stability of the FC voltage, resulting in increased volume and capacity of passive components and limiting its application. To achieve capacitor voltage balance at various modulation indexes with a modulation method, this article proposes a hybrid virtual SPWM method that modifies the carrier and modulation waves based on conventional SPWM, achieving FC voltage balance under full-modulation and full-frequency conditions. Due to the advantage of the topology without neutral point voltage control, HVSPWM can be seamlessly switched to the hybrid virtual DPWM, which can achieve different control objectives while satisfying the stability of the FC voltage. The proposed method has the same expansion capability as the topology, meeting the requirements of the future development. The effectiveness of the proposed method is verified by the simulations and experiments.
Coupled ten-switch inverter is a potential solution for paralleled inverters in medium voltage applications due to the lower cost. However, coupled ten-switch inverter lacks medium vectors, which greatly reduces the vector combinations during parallel operation, the existing methods are no longer applicable. To solve this problem, this paper proposes a modulation strategy without the medium vectors to suppress zero-sequence circulation current (ZSCC), common-mode voltage (CMV), neutral point voltage (NPV) deviation. Based on a three-layer objective switching sequences design, low-CMV vectors are utilized to reduce the CMV, the voltage deviations between two inverters are offset by double vector transpositions to suppress ZSCC, P-type and N-type small vectors are utilized alternately in symmetrical sub-sectors to achieve NPV balance. The effectiveness of the proposed method is verified by simulations.
T-NNPC inverter is an attractive topology with fewer switches and good withstand voltage for medium voltage applications. In order to effectively achieve five-level output, the conventional method is an MPC strategy that can quickly track current, ensuring good output performance under fundamental frequency conditions. However, the flying capacitor voltage fluctuates, especially under low-frequency conditions. In addition, the CO-PWM is a potential method for this topology due to the broader voltage level distribution in the vertical direction. Nevertheless, the flying capacitor voltage balancing cannot be guaranteed under the high modulation indexes. To improve voltage balance under various modulation indexes and current frequencies, this paper proposes an improved CO-PWM (ICO-PWM) method whose voltage level distribution is modified to better apply in the T-NNPC topology. Compared to the conventional MPC method, the flying capacitor voltage is more stable, and the fluctuation is reduced by more than five times, especially under low-frequency conditions. The effectiveness of the proposed ICO-PWM method is verified by the simulations and experiments.