Addressing the problem of poor robustness and anti-interference ability in the permanent magnet synchronous motor (PMSM) speed control system, an adaptive fractional-order sliding mode controller based on a fractional-order sliding mode disturbance observer is proposed. Firstly, a mathematical model of a PMSM is established, which combines adaptive control with fractional order sliding mode control to effectively reduce the drawbacks of traditional integer order sliding mode control and improve the control accuracy of the system. At the same time, a new sliding mode approach law is used to replace the traditional exponential approach law, which reduces system buffeting and improves control performance. We use a fractional-order sliding mode observer to observe external disturbances and perform feedforward compensation on the observed disturbance values to improve the system’s anti-interference ability. By combining adaptive control with fractional-order sliding mode techniques, the system mitigates limitations of traditional integer-order approaches. It enhances symmetry preservation in system response and control accuracy under asymmetric conditions. The simulation results show that the motor system using the improved sliding mode disturbance observer and fractional order sliding mode controller can enhance system stability and anti-interference ability, and has better dynamic and steady-state performance.
4 May 2022 in Mathematical Problems in Engineering
The wind speed information measured by the wind speed sensor in the wind turbine generator may differ from sufficient wind speed. Therefore, this paper proposes a new effective wind speed calculation method and applies it to the optimal maximum power point tracking (MPPT) of wind energy. After estimating the turbine torque and its rotor speed, the process reverses the turbines aerodynamic model. The extended state observer (ESO) based on sliding mode control is used to estimate the aerodynamic torque, which solves complex and challenging tuning of the traditional ESO parameters, and replaces the conventional PI controller, thereby improving the anti-interference and robustness of the system. The sliding mode observer (SMO) is used to estimate the rotor speed. While satisfying the conditions of Lyapunovs inequality, the design of the SMO is discussed in detail. The wind speed estimation method proposed for evaluating permanent magnet semidirect drive wind turbine and its application performance in maximum power tracking. The simulation was carried out in MATLAB/Simulink; the simulation confirmed that the estimated wind speed under different wind conditions is accurate. Compared with the traditional PI control, the utilization rate of wind energy is increased by 2, which can be used for the MPPT control of the wind energy conversion system.
PMSM-based flywheel energy storage systems require fast and robust speed regulation in the presence of parameter uncertainty, load disturbances, and measurement noise, while avoiding the cost and reliability limitations associated with mechanical encoders. This paper proposes a sensorless control framework that combines a fractional-order sliding-mode speed controller with a fractional-order sliding-mode observer. To improve dynamic performance, an improved hybrid Aquila Optimizer–African Vulture Optimization Algorithm (IHAOAVOA) is employed to tune the controller parameters, while the observer follows the proposed robust sensorless design. Simulation results show that at the 1000 rpm operating point under a 20 N·m load disturbance, the proposed method limits the startup overshoot to about 0.24%, compared with 8.02% for the PI control and 9.74% for the conventional sliding-mode control. After the disturbance is introduced at s, the speed drop of the proposed method is limited to 2.80%, whereas those of the PI control and conventional sliding-mode control reach 7.20% and 5.60%, respectively. At the 8000 rpm operating point under an 80 N·m load disturbance, the proposed method maintains the same advantage, with an overshoot of about 0.04% and a speed drop of 1.88%, both lower than those of the two benchmark controllers. In sensorless operation, the sensorless scheme with the IHAOAVOA-tuned speed controller also improves transient estimation performance. At the 1000 rpm operating point, the maximum startup speed estimation error is reduced from 41.8 r/min to 34.8 r/min. At the 8000 rpm operating point, the estimation error enters the ±10 r/min band at 0.0671 s, compared with 0.0718 s for the PSO-tuned case. The electromagnetic torque responses further indicate that the proposed tuning strategy improves transient torque smoothness while maintaining comparable steady-state torque behavior. These results demonstrate that the proposed control framework provides an effective balance among fast dynamic response, disturbance rejection, sensorless estimation accuracy, and electromechanical transient smoothness for PMSM-based flywheel energy storage applications.