YAN JIA

Prof. Dr. YAN JIA

Inner Mongolia University of Technology
orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 March 2021 in IEEE Access
Verified
Journal Article
Open access
ZWZE KUN WANG
ZE KUN WANG
YJYAN JIA
YAN JIA
CCChang Cai
Chang Cai
YCYinpeng Chen
Yinpeng Chen
NLNa Li
Na Li
Qingan LiQingan Li
Qingan Li
The integration of energy storage facilities into existing structures will result in increased costs. Therefore, it is of great significance to optimize the configuration of integrated power systems with multienergy flows to reduce the cost of the comprehensive utilization of energy. This study established a wind-solar-battery-fuel cell integrated power supply system to optimize the grid-connected regional power supply. First, the load is given with a known daily energy demand. The optimization goal is to minimize the average annual cost and the loss of power supply probability. The cost model includes the constraints of transportation costs and the benefits of selling hydrogen and oxygen. Then, an improved genetic algorithm is developed to optimize the structure of the wind-solar-battery-fuel cell integrated power supply system. The basic idea of the improved genetic algorithm is to change the coordination mode of the crossover operator and the mutation operator according to the size of the initial population fitness. Finally, according to the calculation results of the improved genetic algorithm, the optimal configuration of the capacity of devices in the system is obtained, verifying the effectiveness of the improved genetic algorithm. The cost calculation result of the genetic algorithm is 18.7% higher than that of the improved genetic algorithm, and it completely converges at approximately 70 steps. The cost calculation result of the particle swarm optimization is 17.1% higher than that of the improved genetic algorithm, and it completely converges at approximately 75 steps. The cost calculation result of the nondominated sorting genetic algorithm is 9.6% higher than that of the improved genetic algorithm, and it completely converges at approximately 58 steps. The system established in this research can fully meet the power demands for a given area and effectively reduce the local curtailment of wind energy and solar energy.

4 May 2022 in Mathematical Problems in Engineering
Verified
Journal Article
Open access
PDF file
FBFengshuo Bian Bian
Fengshuo Bian Bian
KMKeqilao Meng
Keqilao Meng
YJYAN JIA
YAN JIA
JMJianlong Ma
Jianlong Ma
HRHai Rihan
Hai Rihan
The wind speed information measured by the wind speed sensor in the wind turbine generator may differ from sufficient wind speed. Therefore, this paper proposes a new effective wind speed calculation method and applies it to the optimal maximum power point tracking (MPPT) of wind energy. After estimating the turbine torque and its rotor speed, the process reverses the turbines aerodynamic model. The extended state observer (ESO) based on sliding mode control is used to estimate the aerodynamic torque, which solves complex and challenging tuning of the traditional ESO parameters, and replaces the conventional PI controller, thereby improving the anti-interference and robustness of the system. The sliding mode observer (SMO) is used to estimate the rotor speed. While satisfying the conditions of Lyapunovs inequality, the design of the SMO is discussed in detail. The wind speed estimation method proposed for evaluating permanent magnet semidirect drive wind turbine and its application performance in maximum power tracking. The simulation was carried out in MATLAB/Simulink; the simulation confirmed that the estimated wind speed under different wind conditions is accurate. Compared with the traditional PI control, the utilization rate of wind energy is increased by 2, which can be used for the MPPT control of the wind energy conversion system.

1 September 2019 in IOP Conference Series: Earth and Environmental Science
Verified
Conference Paper
Open access
PDF file
MZMeng Zhao
Meng Zhao
MLMeiying Liu
Meiying Liu
XLXiaoyu Liu
Xiaoyu Liu
YJYAN JIA
YAN JIA
The pantograph-contact net model is established, and based on the N-S equation of the pressure correction procedure, the SIMPLE algorithm is used to solve the aerodynamic characteristics of different components of the pantograph under strong crosswind conditions. The effects of different crosswind speeds and different deflection angles on the aerodynamic load law of the pantograph components are discussed. Results show that among the various components of the pantograph, the aerodynamic drag and lift of the skateboard are the largest, and the lateral force of the lower arm and the bottom frame is also the largest. The pitching moment of the upper frame is the largest, and the overturning moment and the lateral moment of the sliding plate, the lower arm and the underframe are larger than before, which needs to be taken into consideration when we do calculations and optimizations. The research results can provide a basis for the operational safety and optimal design of high-speed pantograph under strong crosswind conditions.