Lignin is currently an underutilized part of biomass; thus, further research into lignin could benefit both scientific and commercial endeavors. The present study investigated the potential of kraft lignin as a support material for the removal of hydrogen sulfide (H2S) from gaseous streams, such as biogas. The removal of H2S was enabled by copper ions that were previously adsorbed on kraft lignin. Copper adsorption was based on two different strategies: either directly on lignin particles or by precipitating lignin from a solution in the presence of copper. The H2S concentration after the adsorption column was studied using proton-transfer-reaction mass spectrometry, while the mechanisms involved in the H2S adsorption were studied with X-ray photoelectron spectroscopy. It was determined that elemental sulfur was obtained during the H2S adsorption in the presence of kraft lignin and the differences relative to the adsorption on porous silica as a control are discussed. For kraft lignin, only a relatively low removal capacity of 2 mg of H2S per gram was identified, but certain possibilities to increase the removal capacity are discussed.
Metallic nano- and micro- materials are relevant for a wide range of applications, from catalysis to medicine. To contribute to the green transition, for more sustainable chemical processes, and to make the most of the unique properties of such material, it is essential to develop synthesis methods compatible with the principles of Sustainable Chemistry. In several syntheses, a metal precursor is reduced in a solvent by reducing agents in a liquid phase. However, these reducing agents and solvents are typically sacrificial and/or difficult to recover. Here, we demonstrate a method that follows more closely the principles of Sustainable Chemistry, where the reduction of 2-ethylanthraquinone (2-EAQ) by H2 makes it possible to further mediate the production of metal nanoparticles by reduction of a metal precursor. Conveniently, 2-EAQ is a molecule widely used in the industry for the production of H2O2 and 2-EAQ is easily reduced with hydrogen at room temperature over a commercial nickel catalyst. As an example, the reduced form of 2-EAQ can be used to reduce copper(II)tetrafluoroborate in tetrahydrofuran at room temperature. The effect of the ratios of the chemicals on the size of the resulting materials is investigated. It is found acidity of the medium is crucial to tune the selectivity of the reduction to that either copper(I)oxide or pure copper material. Solvent and reducing agent can be recovered and regenerated multiple times, paving the way to more sustainable syntheses of metallic particles that generate less waste and avoid the use of sacrificial reducing agents.
This study presents a practical approach for characterizing industrial water-splitting nickel foam electrodes under both cathodic and anodic conditions by employing synchrotron radiation near-ambient pressure X-ray photoelectron spectroscopy (NAP-XPS). The in-situ studies reveal quantitatively reduced and oxidized Ni species on the electrode surface by recording the Ni 2p3/2 signals after cycling the potential in cathodic and anodic regions, respectively. Operando studies demonstrate that a stable electrolyte film forms, allowing the probing of the solid/liquid interface under applied potentials. We attribute this stability to capillary forces within the porous structure of the foam, which enables the monitoring of surface deprotonation under anodic potentials and surface protonation under cathodic potentials. Given that the most common industrial alkaline water electrolyzer electrodes are based on nickel foams similar to the samples measured in this study, the demonstrated method offers a valuable approach for fundamental NAP-XPS examination directly on industrially employed electrodes.