Dávid Csemány

Mr. Dávid Csemány


Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 November 2023 in Fuel
Verified
Journal Article
Closed access
JJJan Jedelský
Jan Jedelský
MMMilan Malý
Milan Malý
SVSai Krishna Vankeswaram
Sai Krishna Vankeswaram
MZMatouš Zaremba
Matouš Zaremba
RKRéka Kardos
Réka Kardos
VJViktor Józsa
Viktor Józsa


19 July 2023 in Heat and Mass Transfer
Verified
Journal Article
Open access
PDF file
DCDávid Béla Csemány
Dávid Béla Csemány
The measurement data of single droplet evaporation experiments are often biased due to the extra heat input through the fiber suspension and the presence of thermal radiation in hot environments. This encumbers model validation for heat and mass transfer simulations of liquid droplets. In this paper, a thermal analysis of this measurement layout is presented with a coupled lumped parameter model, considering heat conduction through the suspension. The model was validated by experimental data from the literature and good agreements were found. The thermal analysis focused on fiber material and geometry, and thermal radiation properties. Calculations were performed on a broad range of ambient conditions for liquids with different volatility characteristics. Temporal squared droplet diameter- and temperature-profiles, furthermore, droplet stationary evaporation rate were used to characterize vaporization phenomena. The thermal balance of the droplet is dominated by the convective heat rate from the environment in the early stage of evaporation. The effect of heat conduction through the fiber becomes important at the end of the droplet lifetime when the droplet size is decreased. Temperature sensor suspension may seriously bias droplet temperature due to the larger thermal conductivity compared to quartz fiber. Large droplets in high-temperature environments show significant sensitivity to thermal radiation properties, which should be considered in measurements and model validation.

10 October 2023 in International Journal of Hydrogen Energy
Verified
Journal Article
Open access
DFDániel Füzesi
Dániel Füzesi
VJViktor Józsa
Viktor Józsa
DCDávid Béla Csemány
Dávid Béla Csemány

7 December 2017 in Processes
Verified
Journal Article
Open access
PDF file
DCDávid Béla Csemány
Dávid Béla Csemány
VJViktor Józsa
Viktor Józsa
Calculation of evaporation requires accurate thermophysical properties of the liquid. Such data are well-known for conventional fossil fuels. In contrast, e.g., thermal conductivity or dynamic viscosity of the fuel vapor are rarely available for modern liquid fuels. To overcome this problem, molecular models can be used. Currently, the measurement-based properties of n-heptane and diesel oil are compared with estimated values, using the state-of-the-art molecular models to derive the temperature-dependent material properties. Then their effect on droplet evaporation was evaluated. The critical parameters were liquid density, latent heat of vaporization, boiling temperature, and vapor thermal conductivity where the estimation affected the evaporation time notably. Besides a general sensitivity analysis, evaporation modeling in a practical burner ended up with similar results. By calculating droplet motion, the evaporation number, the evaporation-to-residence time ratio can be derived. An empirical cumulative distribution function is used for the spray of the analyzed burner to evaluate evaporation in the mixing tube. Evaporation number did not exceed 0.4, meaning a full evaporation prior to reaching the burner lip in all cases. As droplet inertia depends upon its size, the residence time has a minimum value due to the phenomenon of overshooting.

1 November 2021 in Energy
Verified
Journal Article
Open access
GHGyöngyvér Hidegh
Gyöngyvér Hidegh
DCDávid Béla Csemány
Dávid Béla Csemány
JVJános Vámos
János Vámos
LKLászló Kavas
László Kavas
VJViktor Józsa
Viktor Józsa