In recent years, the achievement of the electromagnetically induced transparency (EIT) effect based on the guided-mode resonance (GMR) effect has attracted extensive attention. However, few works have achieved a double EIT-like effect using this method. In this paper, we numerically achieve a double EIT-like effect in a GMR system with a three-layer silicon nitride waveguide grating structure (WGS), using the multi-level atomic system model for theoretical explanation. In terms of slow light performance, the corresponding two delay times reach 22.59 ps and 8.43 ps, respectively. We also investigate the influence of wavelength detuning of different GMR modes on the transparent window and slow light performance. Furthermore, a wide-band flat-top transparent window was also achieved by appropriately adjusting the wavelength detuning between GMR modes. These results indicate that the EIT-like effect in the WGS has potential application prospects in low-loss slow optical devices, optical sensing, and optical communications.

The realization of the electromagnetically induced transparency (EIT) effect based on guided-mode resonance (GMR) has attracted a lot of attention. However, achieving the multispectral EIT effect in this way has not been studied. Here, we numerically realize a double EIT-ike effect with extremely high Q factors based on a GMR system with the double-bar dielectric grating structure, and the Q factors can reach 35,104 and 24,423, respectively. Moreover, the resonance wavelengths of the two EIT peaks can be flexibly controlled by changing the corresponding structural parameters. The figure of merit (FOM) of the dual-mode refractive index sensor based on this system can reach 571.88 and 587.42, respectively. Our work provides a novel method to achieve double EIT-like effects, which can be applied to the dual mode sensor, dual channel slow light and so on.

A subwavelength fine-structured silicon–gold metagrating was designed for realizing mid-infrared (mid-IR) narrowband absorbers. The metagrating consisted of a silicon grating on the stack of a gold film and a quartz substrate. The silicon grating consisted of two periodically arranged silicon strips in each unit cell. The numerical results reveal that perfect absorption of the traverse-magnetic (TM) polarized light at a wavelength of 4.071 μm can be achieved, with an absorption rate of ~99.2% and an absorption full-width at half-maximum (FWHM) bandwidth of ~31 nm. Thus, the proposed structure is useful for the spectral control of mid-IR signals. When used as a refractive index sensor, the structure has a measuring range of 1.0–2.0 with a quasi linear response, with a figure of merit (FOM) of ~103.