Sustainable production of electricity from renewable sources by microorganisms is considered an attractive alternative to energy production from fossil fuels. In recent years, research on microbial fuel cells (MFCs) technology for electricity production has increased. However, there are problems with up-scaling MFCs due to the fairly low power output and high operational costs. One of the approaches to improving energy generation in MFCs is by modifying the existing anode materials to provide more electrochemically active sites and improve the adhesion of microorganisms. The aim of this review is to present the effect of anode modification with carbon compounds, metallic nanomaterials, and polymers and the effect that these modifications have on the structure of the microbiological community inhabiting the anode surface. This review summarizes the advantages and disadvantages of individual materials as well as possibilities for using them for environmentally friendly production of electricity in MFCs.

Sewage sludge is a rich source of phosphorus. The kinetics of orthophosphate release and the efficiency of phosphorus recovery from aerobic granular sludge (GS) and activated sludge (AS) were compared at external organics (F) to biomass (M) ratios that ranged from 0 to 0.10. Changes in the F/M ratio affected orthophosphates release from AS to a greater extent than their release from GS. On average, increasing the F/M ratio by 0.02 increased the rate of phosphorus release from AS and GS by 2.12 and 1.75 mg P/(L h), respectively. Phosphorus release was highest at an F/M ratio of 0.04 (114.03 and 60.71 mg P/L from AS and GS, respectively). The efficiency of phosphorus recovery from AS ranged from 51.3 to 56.1%; the efficiency of its recovery from GS ranged from 32.8 to 37.5%. From GS, mostly inorganic phosphorus was released (about 8.5 mg/g MLSS), most of which was NAIP, i.e. phosphorus bound to Fe, Mn and Al. At a stoichiometric dose of MgO to PO₄³⁻, the precipitation efficiency was 30.13% ± 4.51 with uncontrolled pH and reached 81.73% ± 0.17 at a controlled pH of 10.

Development of economical and environment-friendly Microbial Fuel Cells (MFCs) technology should be associated with waste management. However, current knowledge regarding microbiological bases of electricity production from complex waste substrates is insufficient. In the following study, microbial composition and electricity generation were investigated in MFCs powered with waste volatile fatty acids (VFAs) from anaerobic digestion of primary sludge. Two anode sizes were tested, resulting in organic loading rates (OLRs) of 69.12 and 36.21 mg chemical oxygen demand (COD)/(g MLSS∙d) in MFC1 and MFC2, respectively. Time of MFC operation affected the microbial structure and the use of waste VFAs promoted microbial diversity. High abundance of Deftia sp. and Methanobacterium sp. characterized start-up period in MFCs. During stable operation, higher OLR in MFC1 favored growth of exoelectrogens from Rhodopseudomonas sp. (13.2%) resulting in a higher and more stable electricity production in comparison with MFC2. At a lower OLR in MFC2, the percentage of exoelectrogens in biomass decreased, while the abundance of genera Leucobacter, Frigoribacterium and Phenylobacterium increased. In turn, this efficiently decomposed complex organic substances, favoring high and stable COD removal (over 85%). Independent of the anode size, Clostridium sp. and exoelectrogens belonging to genera Desulfobulbus and Acinetobacter were abundant in MFCs powered with waste VFAs.

This study investigated how anode electrode modification with iron affects the microbiome and electricity generation of microbial fuel cells (MFCs) fed with municipal wastewater. Doses of 0.0 (control), 0.05, 0.1, 0.2, and 0.4 g Fe₂O₃ per the total anode electrode area were tested. Fe₂O₃ doses from 0.05 to 0.2 g improved electricity generation; with a dose of 0.10 g Fe₂O₃, the cell power was highest (1.39 mW/m²), and the internal resistance was lowest (184.9 Ω). Although acetate was the main source of organics in the municipal wastewater, propionic and valeric acids predominated in the outflows from all MFCs. In addition, Fe-modification stimulated the growth of the extracellular polymer producers Zoogloea sp. and Acidovorax sp., which favored biofilm formation. Electrogenic Geobacter sp. had the highest percent abundance in the anode of the control MFC, which generated the least electricity. However, with 0.05 and 0.10 g Fe₂O₃ doses, Pseudomonas sp., Oscillochloris sp., and Rhizobium sp. predominated in the anode microbiomes, and with 0.2 and 0.4 g doses, the electrogens Dechloromonas sp. and Desulfobacter sp. predominated. This is the first study to holistically examine how different amounts of Fe on the anode affect electricity generation, the microbiome, and metabolic products in the outflow of MFCs fed with synthetic municipal wastewater.

The commercialization of microbial fuel cell technology is limited by high operating costs and low electricity production due to poor electron transfer to the anode. Operational costs can be lowered by utilizing waste materials, and cell performance can be improved by anode modification. This study investigated how anode modification with iron compounds changed the efficiency of energy generation and the microbiome of microbial fuel cells fueled with waste volatile fatty acids from a full-scale anaerobic digestion. Anode modification with 2.5 g Fe₂O₃/m² increased the power density, current density, and voltage by 3.6-fold, 1.8-fold, and 1.4-fold, respectively. In the microbial fuel cell influent, propionic, enanthic, and iso-caproic acids predominated (60, 15, and 13% of all volatile fatty acids, respectively); in the outflow, propionic (71%) and valeric acids (17%) predominated. In anodic biofilms, Acidovorax sp. were most abundant; they have a great capacity for volatile fatty acids decomposition, and their abundance doubled in the microbial fuel cell with an iron-modified anode. The presence of iron significantly increased the abundance of the genera Pseudomonas and Geothrix, which were mainly responsible for electricity production. These results indicate that anode modification with iron changes the anode microbiome, favoring efficient volatile fatty acids metabolism and a greater abundance of electrogens in the biofilm, which ensures better electricity generation.

In recent years, much research has focused on energy recovery from biomass as an alternative to fossil fuel usage. Microbial fuel cells (MFCs), which produce electricity via microbial decomposition of organic matter, are of great interest. The performance of an MFC depends on the electrode...