The adsorption of natural pigments onto TiO₂nanoparticles was investigated. The pigments were extracted from the dark purple colored pulp of the berry-like capsule of Kuduk-kuduk (Melastoma malabathricumL.). The Langmuir, Freundlich, Redlich-Peterson, and Sips isotherm models were used to analyze the equilibrium experimental data. Data correlated well with the Sips isotherm model, where the heterogeneity factor (n=0.24) indicated heterogeneous adsorption characteristics, with a maximum adsorption capacity of 0.0130 mg/g. The heterogeneous adsorption character was further supported by results obtained from zeta-potential measurements. When a dye-sensitized solar cell (DSSC) was sensitized with the extracted pigment, the photo-energy conversion efficiency was measured to be 0.83%, thus proving the suitability of Kuduk-kuduk fruit pulp as a sensitizer in DSSCs.

In this paper, a periodic metallic–dielectric nanorod array which consists of Si nanorods coated with 30 nm Ag thin film set in a hexagonal configuration is fabricated and characterized. The fabrication procedure is performed by using nanosphere lithography with reactive ion etching, followed by Ag thin-film deposition. The mechanism of the surface and gap plasmon modes supported by the fabricated structure is numerically demonstrated by the three-dimensional finite element method. The measured and simulated absorptance spectra are observed to have a same trend and a qualitative fit. Our fabricated plasmonic sensor shows an average sensitivity of 340.0 nm/RIU when applied to a refractive index sensor ranging from 1.0 to 1.6. The proposed substrates provide a practical plasmonic nanorod-based sensing platform, and the fabrication methods used are technically effective and low-cost.