Effect of the presence of perforations on thin structure has been extensively investigated for decades. Various perforation parameters were investigated in past studies. However, study on thin cylinder with multiple perforations has not been carried out. In searching for lighter structural members, the concept of perforated hollow section has been inspired by the shape and arrangement of multiple perforations observed in the Cholla skeleton. Effects of multiple perforation parameters on circular hollow section have been the main interest. This paper presents the verification of FEM simulation with test results. A non-perforated circular hollow section (control model) and a circular hollow section penetrated with 12 nos. of circular shape perforations in array arrangement were selected for the verification process. Both test specimen and FEA models were subjected to compression, flexural and torsional loads. For result comparison within the material linear range, FEA models show good agreement with test results for compression and flexural load cases, and for control models under torsional load case. For perforated models under torsional load, FEA results correspond well with the inclined strain gauge readings. FEM analysis method is considered capable to produce reliable result for loading within the material linear range for circular hollow sections with multiple perforations.
This paper presents a study on form-finding of four-stage class one self-equilibrated spine biotensegrity models. Advantageous features such as slenderness and natural curvature of the human spine, as well as the stabilizing network that consists of the spinal column and muscles, were modeled and incorporated in the mathematical formulation of the spine biotensegrity models. Form-finding analysis, which involved determination of independent self-equilibrium stress modes using generalized inverse and their linear combination, was carried out. Form-finding strategy for searching the self-equilibrated models was studied through two approaches: application of various combinations of (1) twist angles and (2) nodal coordinates. A total of three configurations of the spine biotensegrity models with different sizes of triangular cell were successfully established for the first time in this study. All members in the spine biotensegrity models satisfied the assumption of linear elastic material behavior. With the established spine biotensegrity model, the advantageous characteristics of flexibility and versatility of movement can be further studied for potential application in deployable structures and flexible arm in the robotic industry.
The possibility of utilizing treated coal bottom ash as a partial replacement of Portland cement was examined through compressive strength test on mortar samples. A total of 16 batches of mortar mixtures with cement:sand ratio of 1:2.5 and 1:2.75 were prepared using two types of treated coal bottom ash. The chemical compositions including the unburned carbon of coal bottom ash were also analyzed. In order to remove the excess unburned carbon which will affect the potential pozzolanic properties, the coal bottom ash was heated at 550 ± 50oC and 700 ± 50°C for 60 min in an electrical furnace.The results showed that compressive strength of mortar mixtures with cement:sand ratio of 1:2.5 and 1:2.75 containing treated coal bottom ash which was heated at 550oC results in an increase in compressive strength. At 10% and 20% of treated coal bottom ash replacement levels to Portland cement, the compressive strength of the mortar mixture was significantly improved at the age of 28 days. The compressive strength of the mortar mixtures at early ages gives lower strength as compared to the plain Portland cement mortar. However, the effect of treated coal bottom ash that was heated at 700°C is to reduce the compressive strength of the mortar mixtures except for mixture with cement:sand ratio of 1:2.5 containing 10% coal bottom ash at 56 days.