Equivalent electrical circuits (ECM) have proven to be effective in modeling the dynamic behavior of proton exchange membrane (PEM) electrolyzer voltage response. They are a valuable tool for studying the interactions between power electronics and PEM electrolyzers during dynamic operating conditions. Generally, the ECM takes into consideration the activation over-voltage that is present at both the anode and the cathode for the dynamic part of the model. Therefore, the monitoring of the ECM activation over-voltage is an important issue for the correct modeling of the PEM electrolyzer voltage. However, voltage sensors for this over-voltage are expensive and the reported observers of the PEM electrolyzer activation over-voltage are scarce and have not been validated over a sufficiently long time. This work aims at overcoming these drawbacks by proposing the use of a Luenberger observer to accurately estimate the activation over-voltage using an ECM. Based on this proposal, it is possible to build a device capable of emulating the electrolyzer voltage efficiently. Furthermore, a stability analysis of the observable system is provided to ensure its performance throughout the experiment period. Statistical results, based on experimental voltage data from a PEM electrolyzer QL–300, demonstrate the high accuracy and performance of the Luenberger observer under continuous changes in input currents, which demonstrates its robustness.
The self-discharge phenomenon results in a decrease of the open-circuit voltage (OCV), which occurs when an electrochemical device is disconnected from the power source. Although the self-discharge phenomenon has widely been investigated for energy storage devices such as batteries and supercapacitors, no previous works have been reported in the literature about this phenomenon for electrolyzers. For this reason, this work is mainly focused on investigating the self-discharge voltage that occurs in a proton exchange membrane (PEM) electrolyzer. To investigate this voltage drop for modeling purposes, experiments have been performed on a commercial PEM electrolyzer to analyze the decrease in the OCV. One model was developed based on different tests carried out on a commercial-400 W PEM electrolyzer for the self-discharge voltage. The proposed model has been compared with the experimental data to assess its effectiveness in modeling the self-discharge phenomenon. Thus, by taking into account this voltage drop in the modeling, simulations with a higher degree of reliability were obtained when predicting the behavior of PEM electrolyzers.
Proton exchange membrane fuel cell (PEMFC) emulators are feasible solutions for conducting low-cost and safe developments. These types of systems have attracted the attention of global PEMFC manufacturers and research groups over the last few years. Owing to these emulators, it has been possible to develop and optimize PEMFC systems including power electronics and control without the need to use or damage a real PEMFC. However, despite the importance of PEMFC emulators in research, reported studies on this topic remain scarce. For this reason, this review describes the main characteristics and different types of PEMFC emulators (i.e., pseudo and electronic emulators), providing a basis for new emulator prototypes. Additionally, in this paper, the mathematical models that complement PEMFC emulators are presented (i.e., these models and emulators generate reliable measurements compared with real PEMFC systems). Examples of electronic circuit designs based on mathematical models (electrical and heat) are also presented to give some insight into the construction of new PEMFC emulators. Therefore, this paper proposes tools for the construction of new PEMFC emulators to boost the development of this technology.