To determine the relationship between underground mining, groundwater storage change, and surface deformation, we first used two sets of ENVISAT data and one set of Sentinel-1A data to obtain surface deformation in eastern Xuzhou coalfield based on the temporarily coherent point interferometric synthetic aperture radar (TCPInSAR) technique. By comparison with underground mining activities, it indicated that the surface subsidence is mainly related to mine exploitation and residual subsidence in the goaf, while the surface uplift is mainly related to restoration of the groundwater level. The average groundwater storage change in the eastern Xuzhou coalfield from January 2005 to June 2017 was obtained through the Gravity Recovery and Climate Experiment (GRACE) data, and the results indicated that the groundwater storage changed nonlinearly with time. The reliability of the groundwater monitoring results was qualitatively validated by using measured well data from April 2009 to April 2010. Combining with time of mining and mine closing analysis, groundwater storage change within the research area had a strong correlation with drainage activity of underground mining. An analysis was finally conducted on the surface deformation and the groundwater storage change within the corresponding time. The results indicated that the groundwater storage variation in the research area has a great influence on the surface deformation after the mine closed.
1 February 2021 in International Journal of Applied Earth Observation and Geoinformation
Mining goafs can cause many hazards, such as burst water, spontaneous combustion of coal seams, surface collapse, etc. In this paper, a feature-points-based method for the efficient location of mining goafs is proposed. Different interferometric synthetic aperture radar (DInSAR) is used to monitor the subsidence basin caused by mining. Using the principles of the probability integral method (PIM), the inflection points and the boundary points of the basin monitored by DInSAR are determined and used as feature points to locate the goaf. In this paper, the necessity of locating goafs and the traditional methods used for this task are discussed first. Then, the results of verifying the proposed method by both a simulation experiment and real data experiment are presented. Six RADARSAT-2 images from 13th October 2015 to 5th March 2016 were used to acquire the subsidence basin caused by the 15235 working faces of the Jiulong mining area. The average relative errors of the simulation experiment and real data experiment were about 6.43% and 12.59%, respectively. The average absolute errors of the simulation experiment and real data experiment were about 28 m and 38 m, respectively. In the final part of this paper, the error sources are discussed to illustrate the factors that can affect the location result.
Yuyang mine is located in the semiarid western region of China where, due to serious land subsidence caused by underground coal exploitation, the local ecological environment has become more fragile. An advanced interferometric synthetic aperture radar (InSAR) technique, temporarily coherent point InSAR, is applied to measure surface movements caused by different mining conditions. Fifteen high-resolution TerraSAR-X images acquired between October 2, 2012, and March 27, 2013, were processed to generate time-series data for ground deformation. The results show that the maximum accumulated values of subsidence and velocity were 86 mm and , respectively; these measurements were taken above the fully mechanized longwall caving faces. Based on the dynamic land subsidence caused by the exploitation of one working face, the land subsidence range was deduced to have increased 38 m in the mining direction with 11 days’ coal extraction. Although some mining faces were ceased in 2009, they could also have contributed to a small residual deformation of overlying strata. Surface subsidence of the backfill mining region was quite small, the maximum only 21 mm, so backfill exploitation is an effective method for reducing the land subsidence while coal is mined.
Economic development and population expansion in mining cities have led to a growing scarcity of land for construction and thus the closed mines land reuse is extremely urgent. Exploration of the law of surface deformation in closed mine is therefore significance for the development of mining cities. In this study, we first used the StaMSBAS technique to reveal surface deformation of western Xuzhou coalfield from 16/6/2006 to 19/8/2018, based on 77 SAR images. The result of ALOS-1 monitoring was validated by levelling data, and it was shown that the root-mean-square-error and standard deviation were 31.8 mm and 28.9 mm, respectively. The law of surface deformation that occurred before and after mine closure was finally analysed. It was found that: 1) After mine closure, the surface deformation of Jiahe mine experienced the process of subsidence, relative stability and then uplift, and the surface deformations of Zhangxiaolou and Pangzhuang mines changed from slow subsidence to accelerated subsidence. 2) Where the maximum pre-closure subsidence occurred at Jiahe mine, the residual subsidence and uplift that occurred after mine closure was also significant, the correlation coefficients were 0.62 and 0.65, respectively. When the mines were active, surface subsidence of Jiahe and Zhangxiaolou mines was positively correlated with the strike mining degree, with correlation coefficients of 0.90 and 0.83, respectively. After Jiahe mine closure, the residual subsidence was positively correlated with the strike mining degree, and the surface uplift was positively correlated with the depth-to-thickness ratio, the correlation coefficients were both 0.70.