Controllably incorporating multiple immiscible metal elements into one single nanostructure has immeasurable technological and scientific potential, but it remains a challenge for the conventional bottom-up synthetic methods. Herein, we presented a general and scalable route to prepare multi-component nanostructured alloys referred to as nanoporous high-entropy alloys (np-HEAs) by combining bulk melting, fast cooling, and dealloying. To demonstrate this concept, we synthesized senary AlNiCuPtPdAu, octonary AlNiCuPtPdAuCoFe, and senary all-non-noble metal AlNiCuMoCoFe np-HEA with ligament sizes of ∼2–3 nm and precisely controlled composition by dealloying the designed precursor alloys. With a naturally formed thin oxide layer of spinel γ-Al2O3, AlNiCuPtPdAu np-HEA exhibited greatly enhanced high-temperature stability (up to 600 °C) and CO oxidation activity. Interestingly, with the removal of the surface oxide layer, np-HEA still showed good resistance to coarsening at 200 °C for 10 h due to its intrinsically low diffusivity originating from the multiple-principal-element mixing effect. For electrocatalysis, np-HEA with a low Pt loading amount exhibited 10 times the mass activity of Pt/C for oxygen reduction reaction and maintained 92.5% of its initial activity after 100k electrochemical cycles.
12 December 2017 in Energy & Environmental Science
In this study, we explored the behavior of NC_Ar + NH3, an initially highly active catalyst for oxygen electroreduction, in H2/air fuel cells from 0.8 to 0.2 V at 80 °C and 25 °C, in order to find the causes of its instability. We discovered that the decay of the current density always involves the superposition of fast and slow first order kinetics, for which half-lives were obtained. The half-life of the fast decay was practically the same at all potentials and temperatures with a value of around 138 ± 55 min, while the half-life of the slow decay greatly varied from a minimum of ≈2400 min (40 h) to infinity. From the adsorption–desorption isotherm of NC_Ar + NH3, it was deduced that the Fe/N/C carbonaceous catalyst is characterized by interconnected open-end slit-shaped micropores, in which water (with dissolved H+ and O2) quickly flows in the fuel cells if their width is ≥0.7 nm as it has no interaction with the hydrophobic walls of the micropores. The driving force of this quick water flow is the humidified air streaming through the working cathode. Fe–N4-like active sites are thermodynamically stable in stagnant acidic conditions, but according to the Le Chatelier principle, they demetalate in the flux of water running into the micropores. This specific demetalation is the cause of the initial loss of ORR activity of NC_Ar + NH3 catalysts assigned to the fast current decay in fuel cells.
Hydrogen, a renewable and outstanding energy carrier with zero carbon dioxide emission, is regarded as the best alternative to fossil fuels. The most preferred route to large-scale production of hydrogen is by water electrolysis from the intermittent sources (e.g., wind, solar, hydro, and tidal energy). However, the efficiency of water electrolysis is very much dependent on the activity of electrocatalysts. Thus, designing high-effective, stable, and cheap materials for hydrogen evolution reaction (HER) could have a substantial impact on renewable energy technologies. Recently, single-atom catalysts (SACs) have emerged as a new frontier in catalysis science, because SACs have maximum atom-utilization efficiency and excellent catalytic reaction activity. Various synthesis methods and analytical techniques have been adopted to prepare and characterize these SACs. In this review, we discuss recent progress on SACs synthesis, characterization methods, and their catalytic applications. Particularly, we highlight their unique electrochemical characteristics toward HER. Finally, the current key challenges in SACs for HER are pointed out and some potential directions are proposed as well.