The dynamic failure characteristics and fracture process of brittle materials such as rock involves a complex crack propagation process, the underlying mechanics of which is not yet fully understood. At present, the combination of high-speed photography and Digital Image Correlation (DIC) technology is considered to be the most promising and ideal means to observe crack growth and analyze the failure mechanism of rock-like materials. In this work, ultra-high-speed photography is used to investigate the dynamic failure characteristics of fine-grained sandstone, and scanning electron microscope (SEM) is used to investigate the relationship between the mechanical properties and failure law of fine sandstone and strain rate from the micro perspective. Finally, the failure mechanism of the rock is analyzed by combining the DIC technology. It is found that the fine-grained sandstone undergoes five critical moments under impact load, namely, initiation of the first crack, initiation of the second crack, crack penetration, local crushing, and thorough breaking. With the increase of strain rate, the whole failure process of rock specimen is shortened, and the time between two critical moments is shorter and shorter, indicating that the more severe the failure of the rock specimen in a time interval between the critical moments, the shorter the time required for the process, and the less obvious the strain rate effect. The first crack on the rock surface initiates from the direction of the transmission rod. With the increase of the strain rate, the angle between the crack on the rock surface and the axial direction is larger, and the second crack will penetrate the specimen first.
Attacking underground caverns with earth-penetrating bombs usually involves multiple explosions in succession. To assess the dynamic responses and cumulative damage of underground caverns under multiple explosions, based on a reduced-scale physical model test, the modified Riedel–Hiermaier–Thoma (RHT) model in the finite-element software LS-DYNA is used to build an underground cavern model that encounters four explosions above the vault. The characteristics of the stress wave attenuation and the evolution laws for the cumulative damage of the surrounding rock in the process of the four explosions are presented. Also, the displacement of the vault, the strain of the cavern wall, and the damage of a rock bolt-supported cavern and an unanchored cavern are compared. The results indicate that the peak pressure is attenuated increasingly in the latter three explosions. The circumferential strain of the cavern wall changes from tensile to compressive from the vault to the corner. The damage of the surrounding rock on the left and right sides of the explosion source is attenuated with increasing distance from the explosion source, and the attenuation curve has a reverse “S” shape. Moreover, the attenuation rate of the curve decreases with each explosion. Multiple explosions do not affect the size of the crushed zone, but they do increase the range of the fracture zone. With each explosion, the cumulative damage of the surrounding rock increases irreversibly, but the damage increment decreases. The cumulative damage of the surrounding rock exhibits a highly nonlinear relationship with successive explosions, and the effect of the rock bolt reinforcement becomes more obvious with successive explosions. Accordingly, the present research results offer a reference for antiexplosion design and support the optimization of underground engineering.
Adjacent cyclic explosions significantly impact the stability of underground anchored caverns. Based on the similar model test of the vault explosion of the anchored cavern, the dynamic analysis finite element software ANSYS/LSDYNA(18.0) was used to establish a model of the straight wall side explosion of the underground anchored cavern and conduct a numerical simulation. When the total amount of explosion load is the same, we compared the stress time history curve, displacement time history curve, tunnel wall displacement, and circumferential strain curve of the surrounding rock in the underground anchored cavern (under both a high-level single-side blast and a low-level cyclic side blast). We obtained the dynamic response rules of the surrounding rock. By comparing the damage evolution process of the surrounding rock in the two situations, the damage accumulation law of the surrounding rock was analyzed. At the same time, the axial stress distribution characteristics of underground anchor cavern anchors under the action of cyclic explosion were studied. The findings demonstrate that when the total level of blast load adjacent to the cavern is the same, the displacement and circumferential peak strain of surrounding rock and the axial stress of rock bolt in the high-level single explosion are greater than those in the low-level cyclic explosion. However, compared to a single explosion, the rock mass suffers more damage in the cyclic explosion. This study will provide engineers with information that will assist them with a better understanding of the cumulative damage mechanisms of surrounding rock, as well as the stress characteristics of rock bolts under dynamic loads near the explosion site, which will be used to design underground caves with anti-blast features.
The impact of multiple explosion sources on the safety of the underground cavern is enormous. Based on a similarity model test, the finite element software LS‐DYNA3D was utilized to analyze the damage evolution and circumferential strain distribution characteristics of the bolt‐supported cavern under the seven combinations of concentrated charge explosion sources in three places, including the side of the vault, side arch, and sidewall. The accuracy of the simulation results is verified by comparing them with test results. The research results indicate that the damage of the surrounding rock is mainly caused by the tensile stress wave reflected from the free surfaces and the superposition of the tensile stress wave. The damage of the surrounding rock in the cases of multiple explosion sources is not a simple superposition of that in the cases of a single explosion source. The peak circumferential stress and damage of the surrounding rock in the middle of two explosion sources are significantly greater than that of the cases of the corresponding single explosion source. In the seven cases, the peak circumferential strain of the cavern wall changes from tensile to compressive from the vault to the spandrel. When the explosion occurs on the sidewall, the peak circumferential strain of the floor is tensile.