The Xinjiang Uyghur Autonomous Region of China is the largest arid region in Central Asia, and is heavily dependent on glacier melt in high mountains for water supplies. In this paper, glacier and climate changes in Xinjiang during the past decades were comprehensively discussed based on glacier inventory data, individual monitored glacier observations, recent publications, as well as meteorological records. The results show that glaciers have been in continuous mass loss and dimensional shrinkage since the 1960s, although there are spatial differences between mountains and sub-regions, and the significant temperature increase is the dominant controlling factor of glacier change. The mass loss of monitored glaciers in the Tien Shan has accelerated since the late 1990s, but has a slight slowing after 2010. Remote sensing results also show a more negative mass balance in the 2000s and mass loss slowing in the latest decade (2010s) in most regions. This needs further investigation on whether the slowing is general and continuing. In addition, glacier surging occurs more frequently in the Karakoram and Kunlun Mountains.

Surface albedo is an important driver of surface processes that promote glacier melting and is a key variable influencing glacier surface melt. Despite much focus in the literature on variations in albedo and its influence on snow surfaces, little attention has been paid to dust and its impact on bare-ice albedo with respect to glacier melting surfaces. In this paper, spatial changes in glacier albedo were investigated using three Landsat images taken during the ablation season in 2006; temporal variations in albedo were measured by an automatic weather station (AWS) in the ablation zone between 26 June and 1 August 2007 at Urumqi Glacier No. 1 in Tien Shan. Ice and snow samples and reflection spectra at 325–1050 nm were collected in August, 2007 at Urumqi Glacier No. 1. The data suggested that spatial changes in glacier albedo are not prominent after snowfall; however, once ice becomes exposed, glacier albedo varies remarkably and generally increases with elevation, especially around the snow line. Temporal variations are characterized by a large range and high frequency, and most are induced by snowfall, changes in cloud conditions, and surface dust; snowfall and cloud increase glacier albedo. Furthermore, the response of snow albedo is more sensitive to cloud compared with the response of ice albedo. Over a bare ice surface, the albedo generally decreases as the concentration of surface dust increases. Organic matter is a primary factor in reducing the albedo over ice.

For summer-accumulation-type glaciers, the glaciological literature is lacking studies on determining the snow line altitude (SLA) from optical images at the end of the summer as an indicator of the equilibrium line altitude (ELA). This paper presents a workflow for extracting the SLA from Landsat images based on the variation in the albedo with the altitude in the central line area of glaciers. The correlation of >0.8 at the 99% confidence level between the retrieved SLAs with ELAs derived from the interpolation of ground-based, mass balance measurements indicated that the workflow can be applied to derive the SLA from end-of-summer satellite data as an indicator of ELA. The ELA was under-estimated by the calculated SLA. The relationship between the end-of-summer SLA and the ELA depends on the intensity of glacier melting. Subsequently, the workflow was applied to the seven glaciers in the Eastern Tien Shan Mountains, and a time series of the SLA was obtained using 12 end-of-summer Landsat scenes from 1994 to 2016. Over the whole study period, a mean SLA of 4011.6 ± 20.7 m above sea level (a.s.l.) was derived for the seven investigated glaciers, and an increasing SLA was demonstrated. The increase in SLAs was consistent for the seven glaciers from 1994 to 2016. Concerning the spatial variability, the east–west difference was prominent, and these differences exhibited a decreasing trend. The average SLA of each glacier is more influenced by its morpho-topographic variables. The interannual variations in the average SLA are mainly driven by the increasing summer air temperature, and the high correlation with the cumulative summer solid precipitation reflects the characteristics of the summer-accumulation-type glaciers.

In this study, energy and mass balance is quantified using an energy balance model to represent the glacier melt of Urumqi Glacier No. 1, Chinese Tian Shan. Based on data from an Automatic Weather Station (4025 m a.s.l) and the mass balance field survey data nearby on the East Branch of the glacier, the “COupled Snowpack and Ice surface energy and Mass balance model” (COSIMA) was used to derive energy and mass balance simulations during the ablation season of 2018. Results show that the modeled cumulative mass balance (−0.67 ± 0.03 m w.e.) agrees well with the in-situ measurements (−0.64 ± 0.16 m w.e.) (r² = 0.96) with the relative difference within 5% during the study period. The correlation coefficient between modeled and observed surface temperatures is 0.88 for daily means. The main source of melt energy at the glacier surface is net shortwave radiation (84%) and sensible heat flux (16%). The energy expenditures are from net longwave radiation (55%), heat flux for snow/ice melting (32%), latent heat flux of sublimation and evaporation (7%), and subsurface heat flux (6%). The sensitivity testing of mass balance shows that mass balance is more sensitive to temperature increase and precipitation decrease than temperature decrease and precipitation increase.

We measured black carbon (BC) with a seven-wavelength aethalometer (AE-31) at the Nam Co Lake (NCL), the hinterland of the Tibetan Plateau (TP) from May 2015 to April 2016. The daily average concentration of BC was 145 ± 85 ng m⁻³, increasing by 50% since 2006. The seasonal variation of BC shows higher concentrations in spring and summer and lower concentrations in autumn and winter, dominated by the adjacent sources and meteorological conditions. The diurnal variation of BC showed that its concentrations peaked at 9:00–16:00 (UTC + 8), significantly related to local human activities (e.g., animal-manure burning and nearby traffic due to the tourism industry). The concentration-weighted trajectory (CWT) analysis showed that the long-distance transport of BC from South Asia could also be a potential contributor to BC at the NCL, as well as the biomass burning by the surrounding residents. The analyses of the absorption coefficient and absorption Ångström exponent show the consistency of sourcing the BC at the NCL. We suggest here that urgent measures should be taken to protect the atmospheric environment at the NCL, considering the fast-increasing concentrations of BC as an indicator of fuel combustion.

Artificial glacier melt reduction is gaining increasing attention because of rapid glacier retreats and the projected acceleration of future mass losses. However, quantifying the effect of artificial melt reduction on glaciers in China has not been currently reported. Therefore, the case of Urumqi Glacier No.1 (eastern Tien Shan, China) is used to conduct a scientific evaluation of glacier cover efficiency for melt reduction between 24 June and 28 August 2021. By combining two high-resolution digital elevation models derived from terrestrial laser scanning and unmanned aerial vehicles, albedo, and meteorological data, glacier ablation mitigation under three different cover materials was assessed. The results revealed that up to 32% of mass loss was preserved in the protected areas compared with that of the unprotected areas. In contrast to the unprotected glacier surface, the nanofiber material reduced the glacier melt by up to 56%, which was significantly higher than that achieved by geotextiles (29%). This outcome could be attributed to the albedo of the materials and local climate factors. The nanofiber material showed higher albedo than the two geotextiles, dirty snow, clean ice, and dirty ice. Although clean snow had a higher albedo than the other materials, its impact on slowing glacier melt was minor due to the lower snowfall and relatively high air temperature after snowfall in the study area. This indicates that the efficiencies of nanofiber material and geotextiles can be beneficial in high-mountain areas. In general, the results of our study demonstrate that the high potential of glacier cover can help mitigate issues related to regions of higher glacier melt or lacking water resources, as well as tourist attractions.