Deep eutectic solvents (DESs) are promising green solvents for the extraction of compounds from food byproducts. Hazelnut (Corylus avellana L.) is one of the most commonly cultivated tree nuts worldwide. The skin represents one of the major byproducts of the hazelnut industry and accounts for 2.5% of the total hazelnut kernel weight. It is a rich source of phenolic compounds like flavan-3-ols, flavonols, dihydrochalcones, and phenolic acids. In this work, fifteen DESs based on choline chloride and betaine, with different compositions, were studied in order to test their phenolic compounds extraction efficiency through the determination of their total concentration via Folin–Ciocalteu assay. A qualitative analysis of extracted phenolic compounds was assessed by HPLC with UV and MS detection. Using the DES with the best extraction efficiency, a new ultrasound-assisted solid liquid extraction (UA-SLE) method was optimized though the response surface methodology (RSM), taking into account some extraction parameters. Efficient recovery of extracted phenolic compounds was achieved using a 35% water solution of choline chloride and lactic acid (molar ratio 1:2) as an extraction solvent, working at 80 °C and with a solid-to-solvent ratio of 1:25 gmL⁻¹. The optimized conditions made it possible to recover 39% more phenolic compounds compared to a classic organic solvent.

The plastic film residue (PFR) of a plastic waste recycling process was selected as pyrolysis feed. Both thermal and catalytic pyrolysis experiments were performed and coal fly ash (CFA) and X zeolites synthesized from CFA (X/CFA) were used as pyrolysis catalysts. The main goal is to study the effect of low-cost catalysts on yields and quality of pyrolysis oils. NaX/CFA, obtained using the fusion/hydrothermal method, underwent ion exchange followed by calcination in order to produce HX/CFA. Firstly, thermogravimetry and differential scanning calorimetry (TG and DSC, respectively) analyses evaluated the effect of catalysts on the PFR degradation temperature and the process energy demand. Subsequently, pyrolysis was carried out in a bench scale reactor adopting the liquid-phase contact mode. HX/CFA and NaX/CFA reduced the degradation temperature of PFR from 753 to 680 and 744 K, respectively, while the degradation energy from 2.27 to 1.47 and 2.07 MJkg⁻¹, respectively. Pyrolysis runs showed that the highest oil yield (44 wt %) was obtained by HX/CFA, while the main products obtained by thermal pyrolysis were wax and tar. Furthermore, up to 70% of HX/CFA oil was composed by gasoline range hydrocarbons. Finally, the produced gases showed a combustion energy up to 8 times higher than the pyrolysis energy needs.

Yerba mate (Ilex paraguarensis, YM) was used as biomaterial for the removal of anionic and cationic compounds from wastewater. Chromium hexavalent Cr(VI), Remazol brilliant blue (RBB) and methylene blue (MB) were selected as pollutants. A calcination step was performed after the washing and drying steps to evaluate its effectiveness at increasing the adsorption capacity of the solid. Both YM and calcinated YM (CYM) were characterized by means of scanning electron microscopy (FE-SEM), Fourier transform infrared spectroscopy (FT-IR) and Brunauer–Emmett–Teller (BET) analysis. Adsorption batch tests revealed that YM was ineffective for the removal of Cr(VI) and RBB, while good results were obtained for MB (up to 80%) without pH dependency of the adsorption process, and CYM was able to remove Cr(VI) (up to 77%) and RBB (up to 65%) but not MB. The adsorption isotherm of MB on YM at 298 K was obtained experimentally and it is well represented by the Langmuir isotherm. YM’s adsorption capacity for MB was estimated to be 59.6 mg/g. Kinetic batch tests were conducted and the experimental results were fitted with a mathematical model. The low influence of temperature compared to the influence of the YM concentration on the adsorption rate was explained.