Microbial flocs formed from raw textile wastewater in a prototype Aerobic Biofilm Reactor (ABR) system were characterised and studied for their potential use in the treatment of textile wastewater. After 90–100 days of operation, microbial flocs of loose irregular structures were obtained from the reactor with good settling velocity of 33 m/h and sludge volume index (SVI) of 48.2 mL/g. Molecular analysis of the flocs using PCR-amplified 16S rDNA sequence showed 98% homology to those of Bacillus sp, Paenibacillus sp and Acromobacter sp. Detection of Ca2 + (131 mg/g) and Fe2 + (131 mg/g) using atomic absorption spectrometer might be implicated with the flocs formation. In addition, presence of Co2 + and Ni2 + were indicative of the flocs ability to accumulate at least a fraction of the metals' present in the wastewater. When the flocs were used for the treatment of raw textile wastewater, they showed good removal of COD and colour about 55% and 70% respectively, indicating their potential application.
EFB and EFB-based mushroom compost (SMC) from Volvariella volvacea cultivation is a promising energy feedstock because it has adequate nutrient quality. The biochemical methane potential (BMP) and calorific value (CV) of this biomass are investigated. Other analyses such as proximate, compositional, and final analysis; thermogravimetric analysis (TGA); and Fourier transform infrared spectroscopy (FTIR) are also performed. The biomass samples consist of two types of EFB, namely fibers (F) and pellets (P) and SMC from the subsequent cultivation of Volvariella volvacea, with samples FS and PS from the first cultivation and FS2 and PS2 from the second cultivation. P produces the highest biological efficiency (BE) of 28% compared to 9.83% for F. Subsequent cultivation with FS and PS then produces only 2.9 and 6.83% of BE. A higher amount of methane is measured in samples P and PS2, while better biodegradability is observed in PS2 and FS2, suggesting that subsequent cultivation is a good pretreatment of the substrate for anaerobic digestion (AD). CV is highest in F (20.57 MJ/kg), followed by P (19.06 MJ/kg), which is comparable to commercial wood pellet. Samples F, FS, and FS2 have higher ash content, which is due to higher mineral content. The cellulose composition is reduced to almost 50% during cultivation due to fungal metabolism, which is also evidenced by FTIR analysis. TGA analysis revealed that EFB-based SMC exhibits higher weight loss during combustion compared to EFB, which reduces its thermal properties. SMC of EFB is a high potential biomethane feedstock, but not recommended as a fuel pellet.
1 May 2021 in Journal of Pure and Applied Microbiology
Biological treatment for textile wastewater always has a limitation in term of time of reaction and uncertainty along the process. This study focused on the decolorization of synthetic azo dyes in batch reactors with controlled thermotolerant anaerobic conditions. Less-volatile digested sludge collected from a palm oil biogas reactor was used as the organic biodegradation agent for azo dyes. Digested sludge contains high amounts of microbes with uncertain species viable for decolorization purposes. Sodium acetate trihydrate (C2H9NaO5) was used as carbon source and mixed with a specific composition of minimum salt media (MSM) in batch reactors as an additional nutrient. Digested sludge both in mesophilic (35°C) and thermophilic (55°C) conditions were found to be capable of decolorizing 100, 200 and 300 ppm of three types of azo dyes: Reactive Green 19 (45.56%, 69.73%; 63%, 73.49%; 70.02%, 75.92%), Reactive Orange 16 (46.08%, 78.4%; 64.21%, 85.52%; 74.95%, 85.91%) and Reactive Red 120 (29.11%, 85.32%; 63.35%, 87.69%; 72.02%, 89.5%) respectively after 7 days incubation time. Statistical analysis also showed that the anaerobic thermophilic conditions had significantly accelerated the decolorization process. The anaerobic thermophilic environment will be a good factor to include in future textile wastewater treatment plants.
Volvariella volvacea has long been cultivated by farmers, but there are still some limitations to producing high-yielding V. volvacea. Several factors can lead to low yields, including poor substrate utilization and inadequate technology. Therefore, many attempts have been made over the years to improve the biological efficiency of the crop using various approaches. In this review, the existing technologies for yield improvement in V. volvacea production are discussed. This paper also elaborates the current practice including spawn improvement method and cultivation strategy. The smart mushroom house technology equipped with Internet of Things is also presented.