In this study, a thermoelectric energy harvesting system (TEHs) that utilized the heat from the surface of asphalt pavement is proposed with the aim to investigate the effects of the heat conduction using different shape structures in the subterranean level. The design model consisted of asphalt base holder to hold the asphalt, top plate for heating, and bottom plate for cooling. The top plate is exposed on the asphalt surface to harvest heat from sunlight, and the bottom plate is submerged into the pavement. The bottom plate is then connected to the cooling element, to take advantage of subterranean cooling to achieve a high-temperature difference between the top and bottom plate of the TEHs. In the past studies, subterranean cooling proved to maintain the underground temperature, but there is no assurance of high-temperature difference. Simulation and experimental investigation were conducted on how the shape structure affects the heat conduction in the subterranean level for two types of cooling elements, which is a cylindrical rod and flat bar. Both simulation and experimental results demonstrate that the cylindrical rod has yielded a higher temperature difference compared to the flat bar. Higher output voltage was generated for the case of the cylindrical rod due to more effective cooling, which resulted in larger temperature differences. Contradicted to previous studies, the field-testing has proved the system with asphalt has indeed influenced the temperature distribution into the system with a 24.39% increase of temperature difference in comparison to the system without the asphalt. Hence, the introduction of subterranean cooling and asphalt pavement heating has proved to improve the performance of TEHs, which makes it possible for utilization as an energy harvester.
9 July 2024 in International Journal of Ambient Energy
Renewable energy is the generation of power from natural resources that plays an essential part in our society and economy as it helps reduce emissions for more sustainable future. Therefore, this project aims to analyse two energy harvesting technology, photovoltaic (PV) panels and thermoelectric generators (TEG), in terms of charging and voltage generated from waste heat in a road environment. H-shape heat sinks passive cooling element at subterranean level was implemented to achieve a maximum temperature difference of 15°C for TEG. The top plate, the hot side of TEG, can obtain a maximum of 53°C with a cold side of TEG only increased to 4°C from its initial temperature. Three TEGs connected in series able to charge 5F supercapacitors within 3.5 h, while 3V rated PV solar panel, acquired 15 min to charge the supercapacitor fully. Integrated PV and TEG were evaluated regarding the connection configuration of both energy harvesters into a single system. Series connection of the integrated system takes 29 min to fully charged the supercapacitor where all the results are saved into a microSD card and easily read in Excel. This project provides new insight into the charging performance of the two combinations of energy harvesting technology.