Omer LACIN

Prof. Dr. Omer LACIN


Research Focus & Metrics

Academic Career Length

22Years (2005-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 June 2020 in Environmental Progress & Sustainable Energy
Verified
Journal Article
Closed access
PDF file
FSFatih Sevim
Fatih Sevim
OLOmer LACIN
Omer LACIN
EEEmre Fatih EDİZ
Emre Fatih EDİZ
FDFATİH DEMİR
FATİH DEMİR

1 December 2005 in Journal of Colloid and Interface Science
Verified
Journal Article
Closed access
OLOmer LACIN
Omer LACIN
BBBahar Bayrak
Bahar Bayrak
OKOzlem Korkut
Ozlem Korkut
ESEnes Sayan
Enes Sayan

25 June 2020 in International Journal of Chemical Kinetics
Verified
Journal Article
Closed access
PDF file
FDFATİH DEMİR
FATİH DEMİR
AAAnas Osamah Ali Al‐Ani
Anas Osamah Ali Al‐Ani
OLOmer LACIN
Omer LACIN

18 December 2020 in Sinop Üniversitesi Fen Bilimleri Dergisi
Verified
Journal Article
Open access
AÇAli Çi̇çekçi̇
Ali Çi̇çekçi̇
BDBünyamin Dönmez
Bünyamin Dönmez
EKErbil Kavci
Erbil Kavci
OLOmer LACIN
Omer LACIN
Tr en Bu çalışmada, malahit yeşilinin ham şeftali çekirdeği kabuğu üzerine yaygın adsorpsiyon izoterm modelleri ve termodinamik analizi incelenmiştir. Elde edilen sonuçlardan, korelasyon katsayılarına göre en uygun modelin Freundlich izotermi olduğu belirlenmiştir. Ayrıca, hesaplanan n değerinin 1’den büyük olması adsorbentin heterojen bir yüzeye sahip olduğunu göstermiştir. Langmuir izoterm modelinde ise, maksimum adsorpsiyon kapasitesi 8.19 mg.g-1 olarak hesaplanmıştır. Ayrıca, termodinamik analizlerden, serbest entalpi değişiminin -21.53 kJ.mol-1 ve Gibbs serbest enerji değerinin ise yaklaşık -39 kJ.mol-1 olması, adsorpsiyon prosesinin ekzotermik , fiziksel karakterli ve kendiliğinden yürüdüğünü ortaya koymaktadır. Sonuç olarak, şeftali çekirdeği kabuğunun, sulu çözeltilerdeki malahit yeşilinin uzaklaştırılması hususunda uygun bir adsorbent olarak kullanılabilir. Ayrıca elde edilen izoterm modeli ve termodinamik parametrelerin, endüstriyel olarak malahit yeşilinin giderilmesi prosesine faydalı veriler sağlanacağı söylenebilir. In this study, common adsorption isotherm models and thermodynamic analysis of malachite green on raw peach kernel peel are investigated. From the results obtained, it is determined that the most suitable model according to the correlation coefficients is Freundlich isotherm. In addition, the calculated n value greater than 1 indicates that the adsorbent has a heterogeneous surface. In Langmuir isotherm model, the maximum adsorption capacity is calculated as 8.19 mg.g-1. Also, from the thermodynamic analysis, the free enthalpy change of -21.53 kJ.mol-1 and the Gibbs free energy value of about -39 kJ.mol-1 reveal that the adsorption process is exothermic, physically and spontaneous. As a result, the peach kernel skin can be used as a suitable adsorbent for removing malachite green in aqueous solutions. In addition, it can be said that the isotherm model and thermodynamic parameters obtained will provide useful data for the industrial greenhouse removal process.

6 March 2023 in Bulletin of the Chemical Society of Ethiopia
Verified
Journal Article
Open access
PDF file
SISıla Sadiye Ilhan
Sıla Sadiye Ilhan
FDFatih Demir
Fatih Demir
OLOmer LACIN
Omer LACIN
FSFatih Sevim
Fatih Sevim
. The solubility of low-grade zinc ores with a selective leaching environmentally friendly reagent has become a focus of great interest since zinc and its compounds have found wide application. For this purpose, lactic acid was used to investigate the selective leaching kinetics of smithsonite ore obtained from Kayseri region. The effects of particle size (137.5-725 µm), acid concentration (0.5-5 M), solid/liquid ratio (0.5/250-3/250 g mL-1), stirring speed (500-800 rpm) and temperature (40-70 °C) parameters on the smithsonite dissolution rate were experimentally studied. The results obtained show that leaching of about 99.8% of zinc is achieved using 425 µm particle size at a reaction temperature of 70 °C for 45 min reaction time with 2 M lactic acid, the solid/liquid ratio of 1/250 g mL-1 and stirring speed of 600 rpm. The statistical analysis of the experimental data obtained from the parameters revealed that smithsonite dissolution was the surface reaction-controlled with an apparent activation energy of 53.62 kJ.moL-1. The kinetic model describing the process was found as KEY WORDS: Smithsonite, Dissolution kinetics, Lactic acid, Zinc lactate Bull. Chem. Soc. Ethiop. 2023, 37(3), 735-744. DOI: https://dx.doi.org/10.4314/bcse.v37i3.15

30 June 2025 in Journal of Sustainable Metallurgy
Verified
Journal Article
Open access
PDF file
OLOmer LACIN
Omer LACIN
FDF. Demir
F. Demir
Boron minerals, which are hydrated borate compounds of alkali and alkaline earth metals such as Na, Ca, and Mg, contain impurities including clay minerals, calcite, dolomite, gypsum, realgar, orpiment, iron oxide, and sulphur. Boric acid, produced from boron minerals, is the most widely used chemical in the industry as it is used as a raw material in the manufacture of various specific boron products. Boron products are among the most commonly utilised materials today, owing to properties such as resistance to chemical effects, light-weight structure, high mechanical strength, and thermal stability. During the production of boric acid, if the impurities in the boron minerals are not controlled due to the different leach reagents used, filtration difficulties will occur in the later stages of the process. Therefore, the purity and yield of boric acid will be adversely affected, and environmental pollution will occur. The most difficult impurities among these are calcium and magnesium. A review of the literature reveals that many leaching studies have been conducted without adequate consideration of such impurities, leading to the aforementioned issues. In studies where impurities were considered, it has been determined that parameters such as reaction time, temperature, solid/liquid ratio, particle size, mixing speed, and acid concentrations significantly influence the presence of calcium and magnesium, as well as the overall quality of boric acid. With this literature review, the remarkable results obtained from many studies on impurities will be compiled into a single article. Thus, it is believed that researchers working on the subject will be greatly facilitated by the information gathered in this review, enabling them to obtain products with higher purity and more environmentally friendly by-products. Graphical Abstract