Track–bridge interaction under the seismic excitation is a dominant factor to the design and operation of railway bridges. A spatial model integrating rails, deck system, stringers, cross beams, suspenders, main trusses, piers and foundations was established in this paper, adopting non-linear springs to simulate the longitudinal resistance between the track and the bridge. The improved Penzien model was utilised to simulate the soil-pile interaction effect and a computer program was developed to generate artificial seismic waves. Comparison of natural vibration characteristics for the track–bridge system with and without considering the track constraint was made. Furthermore, the effects of sensitive parameters were investigated, including the ballast resistance, friction of movable bearings, location of rail expansion joint (REJ), etc. Present study results indicate that the track–bridge interaction enhances the structural integrity and induces relatively higher natural frequencies of the bridge. In general, the response obtained by the ballast resistance specified in the Chinese code is smaller than that by UIC code. Neglecting the friction of movable bearing will lead to over-estimated rail stresses and under-estimated internal forces of some piers in the system. Setting REJ at both beam ends is more efficient to release the seismic stress of the rail on the bridge.
Track–bridge interaction (TBI) is an increasingly essential consideration for the design and operation of railway bridges, especially for the innovative bridge structure systems that constantly spring up over the years. This paper focuses on the characteristics of additional forces in continuous welded rails (CWRs) on the 3 × 70 m integral rigid-frame bridge of the Fuzhou–Xiamen High-Speed Railway, which is a novel high-speed railway (HSR) bridge structure system in China. The differential equations of rail stress and displacement are first investigated and an integrative analysis model comprising of rail, track, bridge and piers is then established. Secondly, the characteristics of representative additional forces are illustrated and the influences of different design parameters are discussed in detail. Furthermore, suitable rail fasteners, optimal layout schemes of adjacent bridges and reasonable stiffness of piers are also studied. The results indicate that the additional expansion force accounts for the largest proportion of additional forces in integral rigid-frame bridges and that resistance reduction obviously weakens the various additional forces caused by the TBI effect, while the broken gap of the rail increases greatly. Small resistance fasteners are recommended to be applied onto this new type of HSR line as these provide reductions in additional stresses of CWRs compared to WJ-8 fasteners. The additional rail stresses after adopting an adjacent span scheme of 4 × 32 m simply supported beams are less than the corresponding stresses in other schemes. The results also show that there is a strong correlation between the minimum threshold value of the pier stiffness and the longitudinal resistance of HSR lines for the integral rigid-frame bridge. This work could serve as a valuable reference for detailed design and safety evaluation of integral rigid-frame bridges.
The wind-sensitive long-span suspension bridge is a vital element in land transportation. Understanding the wind characteristics at the bridge site is thus of great significance to the wind- resistant analysis of such a flexible structure. In this study, a strong wind event from a landfall typhoon called Soudelor recorded at the Jiangyin Bridge site with the anemometer is taken as the research object. As inherent time-varying trends are frequently captured in typhoon events, the wind characteristics of Soudelor are analyzed in a non-stationary perspective. The time-varying mean is first extracted with the wavelet-based self-adaptive method. Then, the non-stationary turbulent wind characteristics, e.g.; turbulence intensity, gust factor, turbulence integral scale, and power spectral density, are investigated and compared with the results from the stationary analysis. The comparison highlights the importance of non-stationary considerations of typhoon events, and a transition from stationarity to non-stationarity for the analysis of wind effects. The analytical results could help enrich the database of non-stationary wind characteristics, and are expected to provide references for the wind-resistant analysis of engineering structures in similar areas.
8 August 2014 in Journal of Central South University