Integer ambiguity resolution at a single receiver can be implemented by applying improved satellite products where the fractional-cycle biases (FCBs) have been separated from the integer ambiguities in a network solution. One method to achieve these products is to estimate the FCBs by averaging the fractional parts of the float ambiguity estimates, and the other is to estimate the integer-recovery clocks by fixing the undifferenced ambiguities to integers in advance. In this paper, we theoretically prove the equivalence of the ambiguity-fixed position estimates derived from these two methods by assuming that the FCBs are hardware-dependent and only they are assimilated into the clocks and ambiguities. To verify this equivalence, we implement both methods in the Position and Navigation Data Analyst software to process 1 year of GPS data from a global network of about 350 stations. The mean biases between all daily position estimates derived from these two methods are only 0.2, 0.1 and 0.0 mm, whereas the standard deviations of all position differences are only 1.3, 0.8 and 2.0 mm for the East, North and Up components, respectively. Moreover, the differences of the position repeatabilities are below 0.2 mm on average for all three components. The RMS of the position estimates minus those from the International GNSS Service weekly solutions for the former method differs by below 0.1 mm on average for each component from that for the latter method. Therefore, considering the recognized millimeter-level precision of current GPS-derived daily positions, these statistics empirically demonstrate the theoretical equivalence of the ambiguity-fixed position estimates derived from these two methods. In practice, we note that the former method is compatible with current official clock-generation methods, whereas the latter method is not, but can potentially lead to slightly better positioning quality.
Global Navigation Satellite System (GNSS) positioning technology has had widespread applications in the structural health monitoring as its overall performance has improved significantly in the last two decades. It is capable of providing timely and accurate structural vibration information such as dynamic displacements and modal frequencies at higher performance than traditional accelerometers. The studies summarized in this paper focus on the improvement of the multi‐sensors and multi‐constellation data acquisition techniques, the improvement of multiple approaches for erroneous noise mitigation, and innovative modal parameter identification methods. We also detailed the applications of GNSS on the deformation monitoring for towers, chimneys, tall buildings, and bridges. With continuous enhancements in the algorithm and hardware of GNSS, it is expected that the application of GNSS technology can be expanded to other fields such as bridge cable‐force measurements and bridge weight‐in‐motion as well as structural deformation monitoring.
Integer ambiguity resolution at a single receiver can be achieved if the fractional-cycle biases are separated from the ambiguity estimates in precise point positioning (PPP). Despite the improved positioning accuracy by such integer resolution, the convergence to an ambiguity-fixed solution normally requires a few tens of minutes. Even worse, these convergences can repeatedly occur on the occasion of loss of tracking locks for many satellites if an open sky-view is not constantly available, consequently totally destroying the practicability of real-time PPP. In this study, in case of such re-convergences, we develop a method in which ionospheric delays are precisely predicted to significantly accelerate the integer ambiguity resolution. The effectiveness of this method consists in two aspects: first, wide-lane ambiguities can be rapidly resolved using the ionosphere-corrected wide-lane measurements, instead of the noisy Melbourne–Wübbena combination measurements; second, narrow-lane ambiguity resolution can be accelerated under the tight constraints derived from the ionosphere-corrected unambiguous wide-lane measurements. In the test at 90 static stations suffering from simulated total loss of tracking locks, 93.3 and 95.0% of re-convergences to wide-lane and narrow-lane ambiguity resolutions can be achieved within five epochs of 1-Hz measurements, respectively, even though the time latency for the predicted ionospheric delays is up to 180 s. In the test at a mobile van moving in a GPS-adverse environment where satellite number significantly decreases and cycle slips frequently occur, only when the predicted ionospheric delays are applied can the rate of ambiguity-fixed epochs be dramatically improved from 7.7 to 93.6% of all epochs. Therefore, this method can potentially relieve the unrealistic requirement of a continuous open sky-view by most PPP applications and improve the practicability of real-time PPP.
During the design phase of a bridge, certain characteristics are assumed, such as traffic and wind loading. In reality, however, these characteristics can vary, therefore it is very important that the health of such a structure is monitored to evaluate whether it is holding up to the true loading. Due to the ever-increasing size and cost of these structures, it is vital that any anomalies from the expected deflections are detected as soon as possible, allowing remedial action to be taken, and hence trying to prevent disastrous consequences. The use of a kinematic global positioning system (GPS) now allows subcentimeter accuracy to be achieved at a rate of up to 20 Hz, and at maximum distances from the reference GPS receivers to the bridge receivers of up to 20 km. This makes such a system capable of detecting the deflections of long bridges. In addition, accelerometers have been proven useful for such monitoring, allowing precise readings at rates of up to 1,000 Hz. However, both systems have their limita...