Due to the complex nature of the built environment, urban wind flow is unpredictable and characterised by high levels of turbulence and low mean wind speed. Yet, there is a potential for harnessing urban wind power by carefully integrating wind turbines within the built environment at the optimum locations. This requires a thorough investigation of wind resources to use the suitable wind turbine technology at the correct location—thus, the need for an accurate assessment of wind resources at the proposed site. This paper reviews the commonly used wind assessment tools for the urban wind flow to identify the optimum tool to be used prior to integrating wind turbines in urban areas. In situ measurements, wind tunnel tests, and CFD simulations are analysed and reviewed through their advantages and disadvantages in assessing urban wind flows. The literature shows that CFD simulations are favoured over other most commonly used tools because the tool is relatively easier to use, more efficient in comparing alternative design solutions, and can effectively communicate data visually. The paper concludes with recommendations on best practice guidelines for using CFD simulation in assessing the wind flow within the built environment and emphasises the importance of validating CFD simulation results by other available tools to avoid any associated uncertainties.
One of the main factors affecting the reliability of computational fluid dynamics (CFD) simulations for the urban environment is the Horizontal Homogeneity of the Atmospheric Boundary Layer (HHABL) profile—meaning the vertical profiles of the mean streamwise velocity, the turbulent kinetic energy, and dissipation rate are maintained throughout the streamwise direction of the computational domain. This paper investigates the preservation of the HHABL profile using three different commercial CFD codes—the ANSYS Fluent, the ANSYS CFD, and the Siemens STAR-CCM+ software. Three different cases were considered, identified by their different inlet conditions for the inlet velocity, turbulent kinetic energy, and dissipation rate profiles. Simulations were carried out using the RANS k-ε turbulence model. Slight variations in the eddy viscosity models, as well as in the wall boundary conditions, were identified in the different software, with the standard wall function with roughness being implemented in the Fluent applications, the scalable wall function with roughness in the CFX applications, and the blended wall function option in the STAR-CCM+ simulations. There was a slight difference in the meshing approach in the three different software, with a prism-layer option in the STAR-CCM+ software, which allowed a finer mesh near the wall/ground boundary. The results show all three software are able to preserve the horizontal homogeneity of the ABL—less than 0.5% difference between the software—indicating very similar degrees of accuracy.