The Mode I fracture energy of a polyurethane adhesive with low Young’s modulus was investigated. Metal adherends in standardized double cantilever beam (DCB) tests are typically too stiff for soft adhesives, making it difficult to measure the fracture energy accurately. However, soft adhesives, such as a single-component polyurethane adhesive tested in this paper, are in high demand in the automobile industry. Thus, accurate measurement techniques must be established. Flexible substrates composed of spring steel were used for the DCB tests to accommodate the deformation of the adhesive layer. First, the applicability of the flexible substrates was discussed using specimens bonded with an epoxy adhesive. For soft adhesives, however, the deformation of the adhesive layer must be considered in the calculation methods of the fracture energy. Although the deformation effect on the DCB tests has been discussed with Winkler’s elastic foundation, the crack length must be measured along with the load and displacement. To overcome the difficulty of measuring the crack length, a calculation method based on Winkler’s elastic foundation was introduced applying the compliance-based beam method (CBBM). Finally, the fracture energy of the polyurethane adhesive was discussed by comparing the calculation methods with and without measuring the crack length.
With an increasing demand for adhesives, the durability of joints has become highly important. The fatigue resistance of adhesives has been investigated mainly for epoxies, but in recent years many other resins have been adopted for structural adhesives. Therefore, understanding the fatigue characteristics of these resins is also important. In this study, the cyclic fatigue behavior of a two-part acrylic-based adhesive used for structural bonding was investigated using a fracture-mechanics approach. Fatigue tests for mode I loading were conducted under displacement control using double cantilever beam specimens with varying bond-line thicknesses. When the fatigue crack growth rate per cycle, da/dN, reached 10−5 mm/cycle, the fatigue toughness reduced to 1/10 of the critical fracture energy. In addition, significant changes in the characteristics of fatigue crack growth were observed varying the bond-line thickness and loading conditions. However, the predominance of the adhesive thickness on the fatigue crack growth resistance was confirmed regardless of the initial loading conditions. The thicker the adhesive bond line, the greater the fatigue toughness.
A method for fabricating adhesively bonded joints with graded properties along the bond-line was proposed. By utilizing two types of acrylic adhesives, one hard and the other soft, the properties of the mixture were changed by controlling the mixing ratio. An applicator for the adhesives was developed and used for the experiments, in which property-graded adhesive layers were actually produced. The properties, i.e., stress-strain curves at various points of the property-graded adhesive layer, were experimentally measured, and the validity of the proposed method was confirmed. The Young’s moduli at multiple points of the adhesive layer changed from 34.7 MPa to 634 MPa by changing the mixing ratio of the adhesives.
Double cantilever beam (DCB) tests under impact loading conditions were conducted using a falling-wedge impact test machine and a high-speed camera. The change in mode I fracture energy G IC was investigated in comparison with the results obtained under the quasi-static loading condition. Two types of adhesives with significantly different mechanical properties were used for the DCB tests, and the change in rate dependency of the adhesive types was observed. Adhesively bonded joints have been widely used in various engineering products, such as automobiles, ships and airplanes. The strength of the joints is important for product safety. To evaluate the mode I fracture energy of adhesively bonded joints, DCB tests have been standardized under the quasi-static loading condition. Additionally, several tests have been proposed to evaluate the impact resistance of the joints. However, impact loading makes it difficult to evaluate the fracture energy accurately because of the dynamic effects. Therefore, specialized evaluation methods for dynamic fracture must be considered, and a load-independent analysis of the fracture energy was used to avoid load measurement problems due to the dynamic effects in this study.