In this paper, the electrical and thermal conductivity and morphological behavior of low density polyethylene (LDPE)/multi-walled carbon nanotubes (MWCNTs) + graphene nanoplatelets (GNPs) hybrid nanocomposites (HNCs) have been studied. The distribution of MWCNTs and the hybrid of MWCNTs/GNPs within the polymer matrix has been investigated with scanning electron microscopy (SEM). The results showed that the thermal and electrical conductivity of the LDPE-based nanocomposites increased along with the increasing content of carbon nanofillers. However, one could observe greater improvement in the thermal and electrical conductivity when only MWCNTs have been incorporated. Moreover, the improvement in tensile properties and thermal stability has been observed when carbon nanofillers have been mixed with LDPE. At the same time, the increasing content of MWCNTs and MWCNTs/GNPs caused an increase in the melt viscosity with only little effect on phase transition temperatures.

This study investigates the frequency–temperature relations between the phase angle φ and admittance Y for composites of cellulose, synthetic ester, and water nanoparticles. We determined the activation energy value for the relaxation time of a phase shift angle ΔW_φ ≈ (0.783 ± 0.0744) eV, which was related to the shift of φ(f) waveforms in higher frequency area with increasing temperature. We found that the position of admittance frequency waveforms in double logarithmic coordinates was simultaneously influenced by the temperature dependence of admittance and its relaxation time. Activation energy values for the relaxation time of admittance ΔW_τ ≈ (0.796 ± 0.0139) eV and the activation energy value of admittance ∆W_Y ≈ (0.800 ± 0.0162) eV were determined. It was found that all three activation energy values were identical and their average was ΔW ≈ (0.793 ± 0.0453) eV. Impregnation with synthetic ester resulted in a decrease of activation energy by 0.26 eV compared to the impregnation with insulating oil. This was related to higher dielectric permittivity of the synthetic ester.

This paper presents the dielectric response of the insulation of bushings as an effect of the simulated long-term aging process. The experiment was conducted under a condition of a high temperature difference between the current circuit and the cover. The dielectric response was measured with the FDS (Frequency Dielectric Spectroscopy) and the SVM (Step Voltage Measurement) methods. The research has shown the correlation between the aging time and some parameters obtained with the FDS and SVM analysis.

Cross-linked polyethylene (XLPE) is one of the most popular insulation materials used in the production of medium and high voltage cables (MV, HV). This article presents the results of research carried out on two types of commercially used insulation materials, modified with the addition of organophilic phyllosilicate (CLOISITE C20A)and halloysite nanotubes (HNTs). The influence of fillers on the mechanical properties of insulating materials is discussed as a potential mechanism for increasing their resistance to the phenomenon of water-tree. SEM and XRD analyses were performed to investigate the morphology and DSC for comparing phase transitions. Mechanical and functional properties for different concentrations of nanofillers, such as their hybrids, were also investigated.

In this study, the conductivity and permittivity of electrical pressboard—insulating liquid—water composites were investigated, and the electrical properties of the composites and water were analysed comparatively. Mineral oil and synthetic ester were used as insulating liquids. It was found that the presence of water caused an increase in the permeability of the composite in the frequency range below 100 Hz. The value of static permittivity determined by water in the content of 5 wt. % was approximately 15. To obtain this value caused by liquid water, its volume should be approximately five (oil) and four times (ester) higher than its actual content, respectively. The determined values of the activation energy of the DC conductivity of the composites were several times higher than the values of the activation energy of the conductivity of the liquid water. The experimental values of the dielectric relaxation times were many orders of magnitude higher than the dielectric relaxation times of water. This means that the experimental results obtained for the dielectric permittivity, the activation energy of conductivity and the dielectric relaxation times for moisture electrical pressboard impregnated by mineral oil or synthetic ester exclude the possibility of the presence of liquid water in the composites. It was found that the conductivity of the composites increased exponentially with increasing water content. Such dependencies are characteristic of hopping conductivity, caused by the quantum phenomenon of electron tunnelling between nanometre-sized potential wells. As the increase in conductivity is determined by the presence of water in the composites, therefore, the nanometre potential wells were single-water molecules or nanodrops.

In this study, the temperature–frequency dependencies of the pressboard–bio-oil–water nanoparticle composite’s fundamental parameters—phase shift angle and admittance—were examined using the Frequency Domain Spectroscopy method. Measurements were conducted in a frequency range of 10⁻⁴ Hz to 5 × 10³ Hz at temperatures ranging from 293.15 K to 343.15 K, with a step of 10 K. The temperature stabilization accuracy was less than ±0.05 K. A total of 15 Arrhenius plots were determined for various phase shift angle values, from which 15 values and the average activation energy of relaxation time were determined. Similarly, the values of the activation energy of admittance relaxation time and the activation energy of admittance were determined. It was established that all three average values are identical within the bounds of uncertainty. Based on 45 values, a generalized activation energy was determined, with a value of ΔW ≈ (1.032 ± 0.0196) eV. Using the generalized activation energy value, the phase shift angle curves determined for all temperatures were recalculated to a temperature of 293.15 K. It was found that after conversion, all curves perfectly overlap. A similar operation was carried out for the frequency dependencies of admittance. In this case, too, the recalculated dependencies perfectly match. This means that the shape of the frequency dependencies of the phase shift angle and admittance depends solely on the moisture content in the pressboard–bio-oil–water nanodrop composite. The position of the curves in doubly logarithmic coordinates depends only on temperature and is determined by the generalized activation energy Using the generalized activation energy determined in this study will allow for the development of accurate methods for estimating moisture content in cellulose insulation of power transformers containing bio-oil. This will contribute to the detection of critical moisture content, which is about 5% by weight, and to the elimination of the risk, associated with such a high moisture content, of catastrophic failure of power transformers.