Simulation of Standalone photovoltaic systems is essential to predict the performances of an eventual installation of such facility. Simulation tool enables determination of minimums and peak electricity production. This paper presents the evaluation of standalone photovoltaic system using the software package PVsyst. The objective of the simulation work was to design a reliable SAPV system and predicts its yearly energy production efficiency. SAPV configuration simulation was presented using PVsyst software. The total electrical energy that may be supplied by the system as well as power losses were also determined. The accurate determination of the optimum tilt angle for the location of interest is essential for maximum energy production by the system, by the optimization tool in our software Pvsyst, for determining this optimal tilt. This article described a practical implementation of solar photovoltaic system to supply power to a semi-arid location of Ghardaïa. Of the obtained results were the configuration and the optimal size of the generator. Also given were total power fluxes and methods of the optimization were sufficiently detailed and discussed.
3 August 2021 in Asian Journal of Research in Chemistry
The aim of this study is to detect the chemical elements of the greenhouse effect from the LIDAR signal. Using a digital program developed by Fortran language, and based on spectral data. In the present work, The LIDAR sample is clearly contains water vapor and carbon dioxide. According to our results, the content of the sample with methane and the non-detection of nitrogen oxide, due to the absence of its absorption signal in the spectral range of the experimental signal. Carbon dioxide is one of the most dangerous greenhouse gases, our results show that 1 mole of this gas requires 1.45 moles of water vapor.
1 October 2023 in ECS Journal of Solid State Science and Technology
This search displays the effects of deposition temperature on the physical properties of MgO-SiO2 thin films. These thin films were deposited on glass substrates using the autoclave method (within 120min) and at temperature deposition range of within a deposition temperature range of 150 °C–300 °C. These films were diagnosed using X-ray diffraction (XRD) and scanning electronic microscopy (SEM) and UV–Vis spectrophotometer for structural, morphological and optical analysis respectively. Using energy dispersive spectroscopy (EDX), the compositional characterization analysis of the MgO-SiO2 films was also carried out. The XRD patterns reveal that the MgO-SiO2 films have a cubic and hexagonal phase polycrystalline composition with the preferential growth direction of (0 0 2) and (0 1 1) respectively. Granular size was found to decrease by increasing the deposition temperature except at 200 °C, The crystal and optical parameters are calculated and discussed in detail. Membranes were found to have an absorption coefficient below (104 Cm−1) which means indirect permissible and forbidden electronic transitions. The SEM observations show that the films have homogeneous surfaces with clear fullness, The experimental results reveal that MgO-SiO2 thin films may be used as an alternative material for environmentally friendly buffer layer.
This paper aims to numerical study of the experimental spectrum, in the context of the diagnosis of solid materials by spectroscopy; the resulting spectrum of fluorine plasma has beenanalyzed. The plasma is generated after the sublimation of the solid sample the fluorine by Laser Induced Breakdown Spectroscopy (LIBS technique). The theoretical spectra and the electronic temperature of a obtained plasma have been calculated, this temperature (1.92 eV) is well matched to the laboratory plasma criteria. The main results also are showed that the resulting medium consisted of 96.63% Calcium and 3.36% Fluor.