8 September 2021 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
Helicoidal water-air geothermal heat exchanger (HWAGHE) uses the water well as a heat source/sink for air refreshing purposes in space. It has been exploited as a passive technique to minimize the energy uses in buildings. This work goals to estimate the energy and exergy characteristics of HWAGHE for arid zone weather condition of Algeria. The helicoidally geometry enhancing the heat exchange with the soil is chosen to decrease the operating cost and the needed area. The studied HWAGHE was constructed from a flexible PVC pipe with 30 m length and 0.6 m diameter. It was immersed into a drilled borehole with 1 m diameter and 5 m depth. The heat exchange rate with the ground and exergy and energy efficiencies of HWAGHE is evaluated. Experimental findings revealed that the inlet ambient temperature has a considerable impact on the HWAGHE performances mainly when the change in temperature between the ambient and the water well increments. Maximal exergy and energetic efficiencies of the HWAGHE, reaching 89% and 92%, respectively, are obtained at 0.035 kg s−1 mass flow rate.
29 July 2022 in Journal of Thermal Engineering
In this paper, the numerical results of the study on geothermal-air heat exchanger in dry areas of Algeria (Ghardaia region) were presented. Computational fluid dynamics equations were solved using our specific code compilated with Fortran. The outputs of the numerical calculations were compared and validated with the experimental results and the outputs of a commercial CFD code. In these conditions, our results present good agreements with an error not exceeding 2%. By using our numerical model, we have calculated the optimum length, the internal diameter, the air velocity of the pipe in winter and summer periods and have determined the optimum depth at different depths. The comparison of two types of pipes making material (PVC and PEHD) has taken into account the characteristics of the Ghardaia-Algeria region (specific heat capacity, density, thermal conductivity and temperature) of the soil. The obtained results proved that the chosen model gives a satisfactory agreement in all the studied variables.
1 June 2020 in Journal of Physics Communications
This paper aims to numerical study of the experimental spectrum, in the context of the diagnosis of solid materials by spectroscopy; the resulting spectrum of fluorine plasma has beenanalyzed. The plasma is generated after the sublimation of the solid sample the fluorine by Laser Induced Breakdown Spectroscopy (LIBS technique). The theoretical spectra and the electronic temperature of a obtained plasma have been calculated, this temperature (1.92 eV) is well matched to the laboratory plasma criteria. The main results also are showed that the resulting medium consisted of 96.63% Calcium and 3.36% Fluor.
2 December 2024 in South Florida Journal of Development
This study presents an analytical and experimental investigation of heat transfer in a fin, specifically a cylindrical rod made of aluminium or a similar material with a known thermal conductivity k. The fin, with a diameter of 0.01 m and a length of 0.35 m, was subjected to controlled heating at one end, and temperatures were recorded at specific points along the fin. The experiment aimed to analyze the temperature distribution and validate theoretical models. A Python program was developed to compare the experimental temperature values with theoretical calculations using the governing heat transfer equations, including Fourier's law and energy balance principles. The study further investigates the thermal performance of the fin under different conditions, considering the effects of ambient air and boundary constraints. The research highlights the importance of fine-tuning the heat transfer coefficient mmm to ensure accurate thermal conductivity estimations for similar materials.