Fluid inclusions in halite are widely used in research to determine the conditions of sedimentation in salt basins and reconstruct the chemical composition of seawater during a specific geological period. However, previous preliminary studies of the genetic types of inclusions, considered in the present research project, have not received due attention. Consequently, we decided to take into account the main distinguishing features of fluid inclusions in halite, belonging to various genetic types. The ultramicrochemical analysis (UMCA) method is one of the several methods that are used for the quantitative determination of the chemical composition of the primary fluid inclusions in halite. We have upgraded that technique, and that allowed us to reduce the analytical error rates of each component determination. The error rates were calculated in the study of Ca-rich and SO₄-rich types of natural sedimentary brines.

Currently, fluid inclusions in halite have been frequently studied for the purpose of paleoclimate reconstruction. For example, to determine the air temperature in the Middle Miocene (Badenian), we examine single-phase primary fluid inclusions of the bottom halites (chevron and full-faceted) and near-surface (cumulate) halites collected from the salt-bearing deposits of the Carpathian region. Our analyses showed that the temperatures of near-bottom brines varied in ranges from 19.5 to 22.0 °C and 24.0 to 26.0 °C, while the temperatures of the surface brines ranged from 34.0 to 36.0 °C. Based on these data, such as an earlier study of lithology and sedimentary structures of the Badenian rock salts, the crystallization of bottom halite developed in the basin from concentrated and cooled near-surface brines of about 30 m depth. Our results comply with the data on the temperature distribution in the modern Dead Sea.

The geochemical data and the study of fluid inclusions in primary halite are invaluable sources of saline basin information. Most of the previous analyses of salt from the Carpathian area have been obtained by studying the halite samples collected from depths not exceeding 1000 m (i.e., from salt mine outcrops or boreholes). In this article, for the first time, we present the results of samples obtained from a deep well where salt occurs below the frontal orogenic wedge at a depth of ~5000 m. The salt core’s petrological studies showed, quite unexpectedly, the presence of the chevron relics, typical for primary halite. Their geochemical data and fluid inclusion study can be used to reconstruct the environment of the salt sedimentation. The bromine, strontium, and rubidium content values indicated that primary brines were of marine origin, and salts may have undergone partial dissolution and redeposition under lower salinity water inflows. The main ions’ (K, Mg, SO₄) ratios in the fluid inclusions were typical for those of the Badenian brines collected from the Carpathian Foredeep’s eastern part. Compared with modern seawater’s chemical composition, this brine contained a slightly lower content of sulfate ions. This was associated with evolutionary changes occurring in the contents of sulfate ions during the Cenozoic.