Epileptic seizure is one of the most common neurological diseases around the world. It is clinical symptoms and/or signs due to abnormal excessive or synchronous neuronal activity in the human brain. Electroencephalogram (EEG) that measures the electrical activity of the brain generated by the cerebral cortex nerve cells, is the most utilized test to detect the seizure activities by visual scanning of EEG signal recordings. Many techniques and methods have been proposed and developed to help the neurophysiologists to automatically detect the seizure activities with high accuracy. This paper presents a review of EEG features that have been proposed to characterize the epileptic seizure activities for the purpose of EEG seizure detection and classification. The relevant and discriminate features are analyzed, and their performance are also compared and discussed.
3-D network-on-chip (NoC) is gaining popularity among designers due to scalability, higher bandwidth, fault tolerance, and reliability. However, the stacking of multiple dies leads to severe thermal problems due to increase in power density. Unequal traffic distribution across the chip and higher power density results in higher on-chip temperature resulting in performance degradation, increase in leakage power, and circuit failure. In this paper, a novel routing method called adaptive thermal-aware routing (ATAR) is proposed to alleviate peak on-chip temperature. The proposed technique is simulated using AccessNoxim simulator. The parameters for simulation are taken from Global Foundries and Tezzaron Semiconductors. Analysis of the simulation and experimental results shows that ATAR-based designs make the on-chip traffic and thermal distribution more uniform. Different traffic patterns are used for the validation of simulation, and 3-D design platforms are developed to demonstrate thermal optimization in high-performance 3-D NoC-based parallel processing systems.
Three-dimensional network-on-chip systems are getting popular among the integrated circuit (IC) manufacturer because of reduced latency, heterogeneous integration of technologies on a single chip, high yield, and consumption of less interconnecting power. However, the addition of functional units in the Z-direction has resulted in higher on-chip temperature and appearance of local hotspots on the die. The increase in temperature degrades the performance, lifetime, reliability, and increases the maintenance cost of 3-D ICs. To keep the heat within an acceptable limit, floorplanning is the widely accepted solution. Proper arrangement of functional units across different layers can lead to uniform thermal distribution in the chip. For systems with high density of elements, few hotspots cannot be eliminated in the floorplanning approach. To overcome, liquid microchannel cooling technology has emerged as an efficient and scalable solution for 3-D network-on-chip. In this paper, we propose a novel hybrid algorithm combining both floor-planning, and liquid microchannel placement to alleviate the hotspots in high-density systems. A mathematical model is proposed to deal with heat transfer due to diffusion, and convention. The proposed approach is independent of topology. Three different topologies: 3-D stacked homogeneous mesh architecture, 3-D stacked heterogeneous mesh architecture, and 3-D stacked ciliated mesh architecture are considered to check the effectiveness of the proposed algorithm in hotspot reduction. A thermal comparison is made with and without the proposed thermal management approach for the above architectures considered. It is observed that there is a significant reduction in on-chip temperature when the proposed thermal management approach is applied.