X-ray imaging is a widely used imaging modality in the medical diagnostic field due to its availability, low cost, high spatial resolution and fast image acquisition. X-ray photons in standard X-ray sources are polychromatic. Detectors that allow to extract the “colour” information of the individual X-rays can lead to contrast enhancement, improved material identification or reduction of beam hardening artifacts at the system level, if we compare them with the widely spread energy integrating detectors. Today, in the field of Computed Tomography (CT), prototypes of clinical grade systems based on Spectral Photon Counting detectors are currently available for clinical research from different companies. One of the key system components in that development is the X-ray photon detector. This paper reviews the photon detection hardware, from the conversion of X-rays into electrical signals to the pulse processing electronics. A review of available photon counting Application Specific Integrated Circuits (ASICs) for spectroscopic X-ray imaging is presented with emphasis on the CT medical imaging application.
A prototype pixel detector readout chip has been developed with a new front-end architecture aimed at eliminating the spectral distortion produced by charge diffusion in highly segmented semiconductor detectors. In the new architecture neighbouring pixels communicate with one another. Charges can be summed event-by-event and the incoming quantum can be assigned as a single hit to the pixel with the biggest charge deposit. In the case where incoming X-ray photons produce fluorescence - a particular issue in high-Z materials - the charge deposited by those fluorescent photons will be included in the charge sum provided that the deposition takes place within the volume of the pixels neighbouring the initial impact point. The chip is configurable such that either the dimensions of each detector pixel match those of one readout pixel or detector pixels are 4 times greater in area than the readout pixels. In the latter case event-by-event summing is still possible between the larger pixels. As well as this innovative analog front-end circuit, each pixel contains comparators, logic circuits and two 15-bit counters. When the larger detector pixels are used these counters can be configured to permit multiple thresholds in a pixel providing colour information. The prototype chip has been designed and manufactured in an 8-metal 0.13mum CMOS technology. First measurements show an electronic pixel noise of ~72 e- rms (Single Pixel Mode) and ~140 e- rms (Charge Summing Mode).
A characterisation of the Timepix4 pixel front-end with a strong focus on timing performance is presented. Externally generated test pulses were used to probe the per-pixel time-to-digital converter (TDC) and measure the time-bin sizes by precisely controlling the test-pulse arrival time in steps of 10 ps. The results indicate that the TDC can achieve a time resolution of 60 ps, provided that a calibration is performed to compensate for frequency variation in the voltage controlled oscillators of the pixel TDCs. The internal clock distribution system of Timepix4 was used to control the arrival time of internally generated analog test pulses in steps of about 20 ps. The analog test pulse mechanism injects a controlled amount of charge directly into the analog front-end (AFE) of the pixel, and was used to measure the time resolution as a function of signal charge, independently of the TDC. It was shown that for the default configuration, the AFE time resolution in the hole-collecting mode is limited to 105 ps. However, this can be improved up to about 60 ps by increasing the preamplifier bias-current at the cost of increased power dissipation. For the electron-collecting mode, an AFE time resolution of 47 ps was measured for a bare Timepix4 device at a signal charge of 21 ke. It was observed that additional input capacitance from a bonded sensor reduces this figure to 62 ps.